Straight Shank Revolution Drill® Series - Allied Machine ...

Guaranteed Test / Demo Application Form
Opening Drill ® and Revolution Drill ®
The following must be filled out completely before test will be considered.
Distributor:
End User:
Contact:
Contact:
Account Number:
Industry:
Phone:
Phone:
Email: Email:
Test Objective List what would make this a successful test. (i.e. Performance, Chip Control, etc.)
Application Information
Hole Diameter: in/mm Depth of Cut: in/mm Tolerance:
Material: Hardness: BHN/Rc Required Finish: RMS
(4150/A36/Cast Iron, etc.)
Material State:
(Flat Stock/Casting/Tube Stock/Hot Rolled/Forging)
Cored Hole Size:
For Opening Drill ® Applications
Machine Information
Machine Type: Builder: Model #:
(Lathe/Screw Machine/Machine Center, etc.) (Haas/Mori Seiki, etc.)
Power: HP/KW Thrust: Lbs./N Orientation: □ Vertical
□ Horizontal
Shank Required: Rigidity: □ Excellent Tool Rotating: □ Yes
(1-1/2” Straight, CV50, etc. ) □ Good □ No
Coolant Information
□ Poor
Coolant Delivery: Coolant Pressure: PSI/kPa
Through Tool/Flood
Coolant Type: Coolant Volume: GPM/LPM
(Air Mist/Oil/Synthetic/Water Soluble, etc.)
Current Process List all tooling, coatings, substrates, speeds and feeds, tool life and any problems.
Requested Tooling
QTY Item Number QTY Item Number
Allied Machine & Engineering Corp.
120 Deeds Drive, Dover, Ohio 44622
Telephone: (330) 343-4283
Fax: (330) 602-3400
Website Address: www.alliedmachine.com
Email Address: info@alliedmachine.com
Allied Machine & Engineering Corp. 19