Clamps

Power clamps, sliding
No. 7500K
Power clamp for injection moulding,
sliding, complete with mounting
Robust clamping element made of alloyed tempered steel,
forged, for variable clamping heights, with sliding base
element. Components:
- Base element
- Carrier element
Order
no.
max. load
[kN]
H min.
H max.
Weight
372961 16 17 51 1240
Note:
To reduce wear to the adjusting bolt, we
recommend using AMF screw compound No.
6339. It possesses a synergistic combination of
highly-effective solid lubricants and is heat-resistant
and does not wash out.
[g]
Advantage:
- max. load 16 kN
- Two joints for minimal wear
- Use on tool plates with T-grooves and pitch
- Low installation height provided by adjusting bolt
with hexagon socket
- Variable positioning with slot in carrier element
Application:
1. Position and fasten carrier element on the tool
plate
2. Push the base element into the desired position
on the carrier table. After this is done, it is ready
for operation.
3. Adjust the height of the clamping arm with the
adjusting bolt and clamp the tool.
4. The very robust design enables quick and easy
clamping.
By kind permission of Robert Bosch GmbH in Waiblingen
STANDARD CLAMPING ELEMENTS
By kind permission of Robert Bosch GmbH in Waiblingen
Specifications subject to change.
2008/7-8GB