Indian Register Quality Systems Operational Procedures Manual ...

Indian Register Quality Systems Operational Procedures ManualIssue No. 1 - Usage of Logo Rules III IRQS - OPM : 19 : 00 Page 4 of 7proportion between the height of the logo and the height of the two lines of textshall be approximately 3:2.The maximum height of the complete accreditation logos on documents shall notexceed 45 mm. The RvA logo may not be larger and never more conspicuous thanthe logo of IRQS.3.31.0Font for MGMT. SYS. & for C 071:Univers 39 thin ultra condensed125% broadened/ corps 72/ Interline83/spacing +30Font for RvA:Univers 49 light ultra condensed125% broadened/corps 72/Interline 83/spacing +303.2 Use of NABCB accreditation markThe regulation is available on the website of the NABCB (www.qcin.org/nabcb).The rules over the use of the logo of NABCB are as follows:3.2.1. A certified client may use the NABCB accreditation logo only incombination with the IRQS’s logo on the supplier's stationery andliterature, subject to the conditions below and to the IRQS's conditions foruse of the registration logo.3.2.2. The use of this logo by the certified organizations will be under the controland supervision of IRQS.3.2.3. The NABCB accreditation logo shall be reproduced in the proportions andthe colors indicated in the appendix ‘A’.3.2.4. The size of the logo shall not normally be reduced below the size15x12mm. In the event of reproduction in smaller size owing to limitationof space, the logo shall be legible with no infilling of space and letters. Thelogo shall be reproduced based on the artwork supplied by IRQS.