Mining & heavy industry tools - Inolec

Haven’s ® GripsMessenger and Guy StrandHaven’s ® Grips – 1604 Series• Designed for use when light, compact grip isdesired and where cable deformation is nota factor.• Gripping pressure of the knurled jaw isapplied to 1/4" (6.35 mm) cable area.✹ Special Order in Australia1604-20Wire Pulling GripsCat. No.LatchModelMin. to Max. CableDiameter inches (mm)JawLengthApprox.Weight Each2,500 lbs. (1,134 kg) Maximum Safe Load1604-10 NA .06" - .25" (1.52 mm - 6.35 mm) N/A 1 lb. (.45 kg)5,000 lbs. (2,268 kg) Maximum Safe Load1604-20 1604-20L .125" - .50" (3.18 mm - 12.70 mm) N/A 2.08 lbs. (1.14 kg)Wire RopeHaven’s ® Grips – 1625 Series• Designed for use when light, compact grip isdesired and where cable deformation is not a factor.• Gripping pressure of the knurled jaw isapplied to 1/4" (6.35 mm) cable area.• All 1625 series have a swing latch to helphold cable in the jaw.Cat. No.Min. to Max. CableDiameter inches (mm)JawLengthApprox.Weight Each8,000 lbs. (3,629 kg) Maximum Safe Load1625-20 ✹ .28" - .75" (7.11 mm - 19.05 mm) N/A 4 lbs. (1.81 kg)1625-20 7/8 ✹ .38" - .88" (9.65 mm - 22.35 mm) N/A 4 lbs. (1.81 kg)1625-20 1 ✹ .50" - 1.00" (12.70 mm - 25.40 mm) N/A 4 lbs. (1.81 kg)Parallel Jaw GripsParallel Jaw Grips – 1685 Series• Lightweight, compact grips pull an exceptionallywide range of cable types and sizes.• Designed with a round inside-jaw contour formaximum contact to minimize cable deformation.• Lower jaw is serrated to firmly grip insulatedcables and conductors.• Design includes a latch that prevents the grip fromfalling in case of jaw disengagement from the cable.• Large-diameter eye accommodates large hooks onhoists, winches and tackle blocks.1685-201604-20L1625-20Cat. No.Min. to Max. CableDiameter inches (mm)JawLengthApprox.Weight Each4,500 lbs. (2,041) Maximum Safe Load1685-20 .157" - .875" (4 mm - 22 mm) 2-1/2" (64 mm) 3 lbs. (1.30 kg)7,500 lbs. (3,400 kg) Maximum Safe Load1685-31 .625" - 1.250" (16 mm - 32 mm) 4-1/2" (114 mm) 5 lbs. (2.27 kg)1685-3164All dimensions are in inches and (millimeters) unless otherwise specified.WARNING: Grips are to be used for temporary installation, not forpermanent anchorage.WARNING: When used on/or near energized lines, ground,insulate, or isolate grip before pulling.WARNING: Do not exceed rated capacity.WARNING: Always match proper size and type of grip to application.WARNING: Before each use, clean jaw area and inspect grip forproper operation to avoid slippage.