USE & CARE MANUAL - Bunn

Indicator LightsStoring the BrewerUnplug the brewer and wait for it to cool. Brewer must be stored upright and above32°F/ 0°C to prevent damage to the Stainless Steel Hot Water Tank. If you do not usetrifecta for an extended period of time, we recommend running two or three cycles ofwater through the brewer prior to brewing coffee or tea.Important Handling InformationTo avoid dropping and damaging the brewer, always grasp the brewer by the sides andbottom, or top and bottom of the brewer.Indicator light Referencetrifecta MB is equipped with a system for displaying helpful feedback. The Brew ButtonLight in conjunction with the Reservoir Light provides valuable feedback or can help youtroubleshoot.suggestionsBrew Button Light andReservoir Light flash (alternateflashing)Brew Button slowly flashes• Brewer is in initial setup mode and must be primedwith water. See Setting Up trifecta on page 3.• Water in the brewer is not up to proper temperatureyet. Wait for the water to heat – the Brew Button willilluminate solid blue when ready.Brew Button is lit (steady glow)• Water is hot and trifecta is ready to brew.Reservoir Light flashes 4 timesafter pushing Brew Button• The Brew Chamber is missing, Latch is not closed orLatch has not been opened and closed since lastbrew cycle.• Open Latch, remove Brew Chamber, replace BrewChamber, close Latch and press the Brew Buttonagain.Reservoir Light flashes rapidlyafter pushing Brew Button• Add water. A minimum of 6 ounces of water isrequired.Brew Button flashes quickly• Brew was interrupted by lifting the Latch or pushingthe Brew Button. The button will continue to flashuntil you push the Brew Button again. Push the BrewButton again and (after a brief pause) the brewer willpush out the contents of the Brew Chamber. Note:Make sure that a cup is positioned on the Drip Tray underthe Brew Chamber prior to pushing Brew Button.10 trifecta ® MB coffee and tea brewer