Oceanic HW443 Series - MacDermid Offshore Solutions

Oceanic HW443 SeriesHW443, HW443ND, HW443RSubsea Production Control FluidsEnvironmental InformationMacDermid maintains worldwide environmental approvals and can offer Oceanic Subsea Production control fluidssuitable for use in every exploration and production region around the world. The current environmental status ofOceanic HW443 fluids in your area can be obtained from our environmental specialists.StorageOceanic HW443 fluids should be stored in dry conditions, ideally out of direct sunlight. Normal storage temperaturerange is 5 to 40°C.Material CompatibilityOceanic HW443 fluids contain performance additives which ensure high levels of compatibility with materials typicallyused in subsea production control equipment. Extensive material compatibility tests have been performed withOceanic HW443 fluids.Ferrous metals (cast iron, carbon steel, .............................. . Compatiblelow & high alloy steels, stainless steels...)Non-ferrous metals (copper, brass, bronze ......................... Compatible with alloys typically used in subsea production control equipment.and other metals and alloys*)................................................ Avoid Zn, Cd, Pb and Mg metals. Aluminum should be hard anodized.Coatings and ceramic materials .......................................... Avoid porous coatings. Compatible with most ceramic parts. Check ceramic coatingsPackaging & sealing materials ............................................. Compatible with standard NBR, HNBR, FFKM, VMQ/FMVQ, CR, TFE/PTFE, PEEK.(elastomers and thermoplastics*).......................................... Some FKM & AU/EU/PU have proven to be incompatibleUmbilical hose liner thermoplastics ...................................... Compatible with Nylon 11, PE and Polyether ester copolymersAbsorbent gasket materials .................................................. Avoid cork, leather, cotton impregnated materialsPaints ................................................................................... Avoid painting internal surfaces.............................................................................................. Cured epoxy, phenolic and nylon based paints are satisfactory. Avoid less resistant.............................................................................................. paints as they soften. Wash spillages immediately with waterFilter elements ..................................................................... Polypropylene and glass fiber filter elements recommended over paper filters* As material compatibility varies from compound to compound and supplier to supplier, consult supplier for recommendations or request specific compatibility tests.MacDermid Offshore SolutionsA Subsidiary of MacDermid GroupManufacturing LocationsUnited KingdomMacDermid Offshore Solutions UKCale Lane, New SpringsWiganWN2 1JRTel: +44 (0)1942 501000Fax: +44 (0)1942 501110E-mail: wigansales@macdermid.comUSAMacDermid Offshore Solutions Ltd223 N BrockmanPasadena, TX 77506USA Tel: (US) 800 521 2589Outside US: +1 713 472 5081Fax: 713 472 2440E-mail: offshoreorders@macdermid.comFor further recommendations, technical information, Health & Safety data sheets, OEM or environmental approvals,email wigansales@macdermid.comTHE CONTROL FLUID TECHNOLOGY LEADERBrazilMacDermid AnionRua Eli Walter Cesar, 110Jd AlvoradaJandira, São PauloCep.: 06612-130Tel: +55 11 4789 8585E-mail: offshoreorders@macdermid.comOceanic HW443 Series | Issue No. 10 Date: Aug 2011 | www.macdermid.com/offshoreAustraliaMacDermid Offshore Solutions29 Dennis StreetCampbellfield, MelbourneVictoria 3061Tel: +61 3 9303 5150Fax: +61 3 9303 5166E-mail: wigansales@macdermid.comOceanic HW443 Series