Procedure for Replacing Axle Shaft - Tuff Torq Parts

More documents

Recommendations

Info

27. Use a box end wrench with outerdiameter near same size as seal to drivethe seal to its final resting position.28. Tap against end of wrench to drive sealabout 1/8” below surface of housing, tothe depth where chamfer on case portends.29. Remove tape after seal has beeninstalled.- 8 -
30. Pour new oil into transmission throughthe access port as shown. Use SAE5W50 synthetic motor oil included in kit.31a. Oil should be added until the levelreaches between 20-25 mm (3/4” - 1”)from lip of port.31b. For transmissions with external orremotely located expansion reservoir,oil should be added to the level markedon tank and/or indicated in operatorsmanual.One expansion tank example is shownat right.32. After cleaning reinstall magnet intoaccess port.- 9 -
Page 1 and 2: Procedure for Replacing Axle Shafti
Page 3 and 4: 8. Axle shaft must be detached from
Page 5 and 6: 16. Install thrust washer between (
Page 7: 24. Apply a generous coating of gre

Procedure for Replacing Axle Shaft - Tuff Torq Parts

Create successful ePaper yourself

Delete template?

Save as template?