200/225/250/3.0 Liter - Mercury

More documents

Recommendations

Info

MAINTENANCEBefore servicing any part of the fuel system, stop engine anddisconnect the battery. Drain the fuel system completely. Use anapproved container to collect and store fuel. Wipe up any spillageimmediately. Material used to contain spillage must be disposedof in an approved receptacle. Any fuel system service must beperformed in a well‐ventilated area. Inspect any completed servicework for sign of fuel leakage.FUEL LINE INSPECTIONVisually inspect the fuel line and primer bulb for cracks, swelling,leaks, hardness, or other signs of deterioration or damage. If anyof these conditions are found, the fuel line or primer bulb must bereplaced.WATER SEPARATING FUEL FILTERNOTE: The warning system will turn on when water in the fuel filterreaches the full level. See Features & Controls - WarningSystem.The water separating fuel filter removes moisture and also debrisfrom the fuel. If the filter becomes filled with water, the water canbe removed. If the filter becomes plugged with debris, the filtermust be replaced with a new filter.1. Remove and replace filter as follows:28434a. Turn ignition key switch to "OFF" position.b. Disconnect wire at bottom of filter.c. Remove filter by turning the filter clockwise. Tip the filter todrain fluid in a suitable container.58
MAINTENANCEd. Lubricate the sealing ring on the filter with oil. Thread onthe filter and tighten securely by hand. Reconnect the wireto the filter.IMPORTANT: Visually inspect for fuel leakage from the filter bysqueezing the primer bulb until firm, forcing fuel into the filter.Steering Link Rod FastenersIMPORTANT: The steering link rod that connects the steeringcable to the engine must be fastened using special washer headbolt ("a" ‐ Part Number 10‐849838) and self‐locking nylon insertlocknuts ("c" & "d" ‐ Part Number 11‐826709113). These locknutsmust never be replaced with common nuts (non‐locking) as theywill work loose and vibrate off freeing the link rod to disengage.! WARNINGImproper fasteners or improper installation procedures can resultin loosening or disengagement of the steering link rod. This cancause a sudden, unexpected loss of boat control, resulting inserious injury or death due to occupants being thrown within orout of the boat. Always use required components and followinstructions and torque procedures.abcd27843a - Special washer head bolt (10‐849838)b - Flat washer (2)c - Nylon insert locknut (11‐826709113)d - Nylon insert locknut (11‐826709113)59
Page 1:
Thank Youfor your purchase of one o
Page 6 and 7:
TABLE OF CONTENTSFuel and OilFuel R
Page 8 and 9:
TABLE OF CONTENTSOwner Service Assi
Page 10 and 11:
WARRANTY INFORMATIONPlan coverage i
Page 12 and 13:
WARRANTY INFORMATIONCONDITIONS THAT
Page 14 and 15:
WARRANTY INFORMATIONDISCLAIMERS AND
Page 16: WARRANTY INFORMATIONWHAT IS NOT COV
Page 20 and 21: Boater's ResponsibilitiesGENERAL IN
Page 22 and 23: GENERAL INFORMATIONWhen choosing a
Page 24: GENERAL INFORMATION• Adding 1 inc
Page 27 and 28: GENERAL INFORMATIONImportant Safety
Page 29 and 30: GENERAL INFORMATIONShift outboard i
Page 31 and 32: GENERAL INFORMATION! WARNINGWave or
Page 34 and 35: WHILE BOAT IS MOVINGGENERAL INFORMA
Page 36 and 37: GENERAL INFORMATIONReport accidents
Page 38 and 39: GENERAL INFORMATIONComponent Identi
Page 40 and 41: FUEL AND OILFuel RecommendationsIMP
Page 42 and 43: FUEL AND OILIMPORTANT: Oil must be
Page 44 and 45: FUEL AND OILAlways stop engine befo
Page 46 and 47: Warning SystemFEATURES AND CONTROLS
Page 48 and 49: FEATURES AND CONTROLSIf Guardian Sy
Page 50 and 51: FEATURES AND CONTROLS! WARNINGOpera
Page 52 and 53: FEATURES AND CONTROLSAUXILIARY TILT
Page 54 and 55: OPERATIONOperating in Saltwater or
Page 56 and 57: OPERATIONb. Change engine speed app
Page 58 and 59: OPERATIONb. Turn the ignition key s
Page 60 and 61: Stopping the EngineOPERATIONReduce
Page 62 and 63: EPA EmissionsMAINTENANCEEMISSION CE
Page 64 and 65: MAINTENANCE• Check control cable
Page 68 and 69: MAINTENANCEDescription Nm lb. in. l
Page 70 and 71: MAINTENANCEThe gearcase has two cor
Page 72 and 73: MAINTENANCE4. Place a block of wood
Page 74 and 75: MAINTENANCE10.Secure propeller nut
Page 76 and 77: MAINTENANCETube RefNo.94Description
Page 78 and 79: MAINTENANCE• Steering Cable Greas
Page 80 and 81: MAINTENANCE4. Remove vent plug and
Page 82 and 83: Storage PreparationSTORAGEThe major
Page 84 and 85: GearcaseSTORAGE• Drain and refill
Page 86 and 87: Engine Runs ErraticallyPOSSIBLE CAU
Page 88 and 89: OWNER SERVICE ASSISTANCE• Model a
Page 90 and 91: Important InformationOUTBOARD INSTA
Page 92 and 93: OUTBOARD INSTALLATIONSome accessori
Page 94 and 95: OUTBOARD INSTALLATION2. Thread the
Page 96 and 97: OUTBOARD INSTALLATION! WARNINGImpro
Page 98 and 99: OUTBOARD INSTALLATIONDetermining Re
Page 100 and 101: OUTBOARD INSTALLATION1. Mark four m
Page 102 and 103: OUTBOARD INSTALLATIONCHECKING BOAT
Page 104 and 105: OUTBOARD INSTALLATIONElectrical, Ho
Page 106 and 107: Dual OutboardsOUTBOARD INSTALLATION
Page 108 and 109: OUTBOARD INSTALLATIONLocating the C
Page 110 and 111: OUTBOARD INSTALLATION2. Place the s
Page 112 and 113: OUTBOARD INSTALLATIONc. Place a thi
Page 114 and 115: 5. Reinstall the cowl seal.OUTBOARD
Page 116 and 117:
OUTBOARD INSTALLATIONPRIMING OIL IN
Page 118 and 119:
Trim In PinOUTBOARD INSTALLATION! W
Page 120:
Maintenance LogMAINTENANCE LOGRecor
show all

200/225/250/3.0 Liter - Mercury

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?