Telescopic forks Telescopic forks

Standard optionsOver many years Meijer Special Equipment has acquired a greatdeal of knowledge enabling us to offer Telescopic forks with specificcustomer options.Palletstops• Y1 palletstops are intended to stop the forks protruding too farthrough the pallet, thus preventing damage to goods and palletsstanding behind.• Y2 palletstops serve the same purpose and can also be used to supporta separate load back rest.• Y3 palletstops support the load and allow frequent repositioningof the forks on the carriage.Extra wear protectionThrough an extra height upgraded steel which is welded under the complete length of outerforks orintegrated inside the taper of the nose.Load back restThe load back rest supports the load and moves forward with the outer fork.It is bolted onto the Y2 palletstops but still allows the distance between the forksto be changed. MSE supplies two types of load back rests, namely a standarddesign and a load back rest for reach lift-trucks.Width under side Width upper side Height700 700 1200700 1000 1200725 1000 1200When the load back rest is used, the effective length of the telescopic forks is reduced by 25 mm. Wherepossible the pallet stops should be moved back 25 mm to prevent this.Other productsDouble Height Shift SystemThe double height shift system can be used toincrease the lift height of a standard lift truck.Single Height Shift SystemThe single height shift system is designed to adjustthe height of one fork to compensate for thehorizontal position of the load.