Battery Safety - CECOM

More documents

Recommendations

Info

LiSO 2 <strong>Battery</strong> DisposalProcessing● USERS MUST NOT ACTIVATE THE CDD● After use turn in all LiSO 2 batteries for proper disposal● The following procedures are to be performed by the authorizeddisposal personnel only:– Slit or remove the CDD label– Gently depress CDD with small screw driver– Separate batteries on all sides by at least 2 inches– Place batteries in secure, well ventilated area for a minimum of 5 days. DO NOTHANDLE!– When cool to the touch measure battery voltage– If voltage less than 1 volt per cell - dispose of as non-hazardous material– If voltage is 1 volt per cell or greater - push CDD a second time, wait 5 more days, andremeasure voltage - or dispose of as hazardous material● Recommendations: Inform battery users of these procedures - Includein TM’s
Primary <strong>Battery</strong>Summary●●●●●●●Replace batteries in matched sets - TM and labelingDo not rely solely on battery diodes to prevent charging - H/WAdequate installation instructions - TMRemove batteries prior to long term storage - TMUse authorized batteries only - labeling and TMDo not use expired batteries - check shelf life extensions - WebUsers are not to activate CDD’s - turn in for processing - TM
Page 1 and 2: Battery SafetyCECOMDirectorate of S
Page 3 and 4: Introduction● Purpose of this tra
Page 5 and 6: AN/PRC-104BBA-5590/U Venting● Two
Page 7 and 8: AN/PSN-11BA-5800 BatteryExplosions
Page 9 and 10: PLGR Power ConnectionOPTIONA24VDC A
Page 11: DTD/ANCD(CYZ-10) Incident● The eq
Page 16 and 17: Ballard BA-5800Batteries● AN/PSN-
Page 20 and 21: Secondary Battery Issues
Page 22 and 23: BB-390A/U NiCdBattery Incident●
Page 24: What’s New and What to LookOut Fo

Battery Safety - CECOM

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?