Black Widow Custom Bows

500
504
505
506
GRAPHITE SHAFTING: People question if graphite arrows are traditional. Well, what is “traditional”? They are as traditional as
fiberglass (remember Micro-flites?) or aluminum shafting, plastic nocks, dacron strings, BoTuff, etc, etc. “Tradition” is in the
mind of the traditionalist. What we do feel strongly about is adequate mass weight of an arrow to absorb more of the bows stored
energy for the purpose of penetration and longevity of the bow. Even the U.S. Congress can not repeal the “Law of Inertia” which,
to a bowhunter, means penetration. Therefore, we recommend an arrow weight of 9 to 12 grains per pound of draw weight. Our
warranty requires a minimum of 8, but long draw lengths (29 inches or more) significantly increase the possibility of limb tip damage
when using a high performance bowstring and lighter weight arrows, therefore 9 to 12 would be safer and wiser. We prefer
either the Gold Tip graphite shaft, because of it’s unique system of adding mass weight to both the point and nock ends of the
shaft (see #510, #511 and #512) or, the Carbon Express shaft, which accepts weight to the point end only (see #511 and #516). #511
Gold Tip Adapter Weights WILL NOT FIT in the 75 or 90 shafts. This system also makes it possible to really fine-tune the shaft
for perfect arrow flight. The greatest advantage of the virtually indestructible graphite shaft is that it allows you to maximize your
accuracy (especially in cold weather) by shooting moderate poundage and should you not get a pass-thru (which may even be
preferable), the graphite shaft is unlikely to be broken off but will continue “working” as the game animal seeks to flee through
the brush.
ALUMINUM SHAFTING: Unfortunately, as you can see below, Easton Aluminum does not make every arrow size in each arrow
color. Consequently the color design you prefer may not be available in the size you need. We apologize for this, but trust you
understand that this is beyond our control. The sizes as listed below begin with the weakest spine and progress to the stiffest
spine. If you want your shafting cut to length, the extra cost is $3.00 per dozen. The length is measured from the bottom of the
nock groove to the end of the shaft.
Measured Arrow Length
507 508 509
Other fletching colors and nock colors available upon special order (by phone) but requires additional time for delivery.
Sorry, no refunds on cut or custom fletch arrows.
500 TUNING SHAFTS: You may order just one (more if you wish) of any of the below full length aluminum, Gold
Tip or Carbon Express shaft sizes for the purpose of bare shaft testing and tuning, as per our Owner’s Manual
Companion DVD, to determine what size shaft shoots best from your bow. Nock included. Please specify SIZE.
ALUM.: With R.P.S.: $6.00 Each With R.P.S. and #568 adapter: $7.00 Each
GOLD TIP: With R.P.S., #510 Nock Adapter and #511 Adapter Weights (210 grains total): $8.00 Each
CARBON EXPRESS : With R.P.S. and #511 Adapter Weights (210 grains total): $8.00 Each
504 EASTON CAMO HUNTER XX75 SHAFTS: This camo looks great in the woods! 1816 and 1916 come packaged
with green “X” Uni-Nocks and “X” Uni-Bushing System. Sizes: 2016, 2114, 2018, 2213, 2215, 2117, 2216, 2315,
2219, and 2317 come packaged with green Super Uni-Nock and the Uni-Bushing System. Offered full length or
cut to length (R.P.S. inserts included). Sorry, no substitutions on nock color (for additional colors see #535 and
#536). Please specify SIZE and LENGTH (if desired).
$66.00 Dozen Cut to length: $69.00 Dozen
505 FLETCHED CAMO HUNTER XX75 ARROWS: One orange and two white 5” artificially barred, shield cut feathers
in a right wing, medium helical. Comes packaged with green Super Uni-Nock and the Uni-Bushing System.
Offered full length or cut to length (R.P.S. inserts included). See #504 for sizes. Sorry, no substitutions on nock color
(for additional nock colors see #535 and #536).Please specify shaft SIZE and LENGTH.
$103.00 Dozen Cut to length: $106.00 Dozen
506 EASTON LEGACY XX75 SHAFTS: Tan color with lifelike, cedar grain pattern and “footed” point end gives
this shaft the traditional look of wood but with the precision of aluminum. Sizes: 1916, 2016, 2018, 2020, 2117,
2216 and 2219. Offered full length or cut to length (R.P.S. inserts included). Nocks not included. Please specify
SIZE and LENGTH (if desired).
$66.00 Dozen Cut to length: $69.00 Dozen
507 FLETCHED LEGACY XX75 ARROWS: One red and two white 5” artificially barred, shield cut feathers in a
right wing, medium helical. Choice of red or white Marco nocks (you glue them on). Offered full length or cut
to length (R.P.S. inserts included). See #506 for sizes. Please specify shaft SIZE, LENGTH (if desired) and nock
COLOR.
$103.00 Dozen Cut to length: $106.00 Dozen
508 GOLD TIP XT GRAPHITE Traditional WOOD GRAIN SHAFTS: Unique five-layer design makes this shaft
incredibly strong and almost indestructible, thus dampening the paradox to improve accuracy and penetration.
(see GRAPHITE SHAFTING above). The Micro-finish woodgrain pattern gives the shaft a classic traditional
touch. Offered with or without #510 Nock Adapter. Sizes: 1535 (7.6 grains per inch), 3555 (8.6 grains per inch),
5575 (9.3 grains per inch) and 7595 (11.5 grains per inch). Offered full length or cut to length ( #512 R.P.S. inserts
included). Please specify WITH or WITHOUT nock adapter, SIZE and LENGTH (if desired).
WITH nock adapter: $93.00 Dozen Cut to length: $96.00 Dozen
WITHOUT nock adapter: $86.00 Dozen Cut to length: $89.00 Dozen
509 GOLD TIP XT GRAPHITE Traditional WOOD GRAIN ARROWS: One red and two white solid colored 5”
shield cut feathers in a right wing, medium helical. Comes with white #536 Super Uni-Nocks (you insert and
align). Offered with or without #510 Nock Adapter. See #508 for sizes. Offered full length or cut to length ( #512
R.P.S. inserts included). Please specify WITH or WITHOUT nock adapter, SIZE, and LENGTH (if desired).
WITH nock adapter: $120.00 Dozen Cut to length: $123.00 Dozen
WITHOUT nock adapter: $113.00 Dozen Cut to length: $116.00 Dozen
PAGE 32
510
511
512
514 515
510 GOLD TIP THREADED NOCK ADAPTER: 20 Grains. Designed for the dual purpose of adding mass
weight and fine tuning (see GRAPHITE SHAFTING above). Fully threaded to allow you to add #511 Adapter
Weights to the nock end of the arrow.
$7.00 Dozen
511 GOLD TIP ADAPTER WEIGHTS: This system makes it possible to not only add weight to the shaft,
but also to change the dynamic spine of the shaft to fine tune it for perfect arrow flight (see GRAPHITE
SHAFTING above). Adding weight only to the point end of a Gold Tip or Carbon Express (except 75’s and 90’s)
causes the shaft to have a weaker “dynamic” spine because the arrow is “pushing” more weight. Adding
weight to the nock end (Gold Tip only) causes the shaft to have a stiffer “dynamic” spine by absorbing more
of the bows energy. Combo Pack comes with 3 dozen 20 grain weights and 3 dozen 50 grain weights which is
enough to add up to 210 grains per arrow to one dozen arrows. Also available in 1 dozen 20 grain and 1 dozen
50 grain. Please specify COMBO PACK, 20 GRAIN or 50 GRAIN.
Combo Pack: $32.00 Six Dozen 20 Grain: $6.00 Dozen 50 Grain: $6.00 Dozen
512 GOLD TIP FULL-THREAD R.P.S. INSERT: 15 grains. Fully threaded which allows you to use the #511
Adapter Weights to add weight to the shaft.(see GRAPHITE SHAFTING above).
$5.00 Dozen
514 CARBON EXPRESS HERITAGE WOOD GRAIN SHAFTS: The traditional look of wood with a durable
precision-wrapped carbon composite construction for extreme toughness and penetration. Size 75 (8.8 grains
per inch), 90 (9.4 grains per inch), a 150 (10 grains per inch), a 250 (11 grains per inch) and a 350 (12 grains per
inch). #516 R.P.S. inserts included for the 150, 250 and 350 shafts. #517 R.P.S. included with the 75 and 90
shafts. (#511 Gold Tip Adapter Weights WILL NOT FIT in the 75 or 90 shafts). Choice of Solid Green, Yellow,
or White #529 Nocks for Size 75 and 90 shafts and Green, Orange or White #534 Nocks,for the 150, 250 or
350 shafts. Offered full length or cut to length. Please specify SIZE, NOCK COLOR and LENGTH (if desired).
$87.00 Dozen Cut to length: $90.00 Dozen
515 FLETCHED CARBON EXPRESS HERITAGE WOOD GRAIN ARROWS: One white artificially barred and two
solid white 5”, shield cut right wing feathers. Offered full length or cut to length #516 R.P.S. inserts included for
the 150, 250 and 350 shafts. #517 R.P.S. included with the 75 and 90 shafts. (#511 Gold Tip Adapter Weights
WILL NOT FIT in the 75 or 90 shafts). See #514 for sizes and nock color. Please specify SIZE, NOCK COLOR and
LENGTH (if desired).
$116.00 Dozen Cut to length: $119.00 Dozen
516 CARBON EXPRESS HERITAGE FULLY THREADED R.P.S. INSERTS: 13 grains. For the Carbon Express
150, 250 and 350 shafts. Fully threaded which allows you to add the #511 adapter weights to the shaft (see
GRAPHITE SHAFTING ABOVE).
$6.00 Dozen
517 CARBON EXPRESS HERITAGE FULLY THREADED R.P.S. INSERTS: 11 grains. For the Carbon Express 75
and 90 shafts. #511 Gold Tip Adapter Weights WILL NOT FIT in the 75 or 90 shafts.
$6.00 Dozen
569 R.P.S. INSERTS: Replaceable Point System inserts are furnished with all standard orders of aluminum shafting
(you may wish to have some extra ones). See # 504 and #506 for sizes. Please specify SIZE.
$3.00 Dozen
FOR A FUN AND INFORMATIVE FORUM, CHECK OUT THE WIDOW WALL ON OUR WEBSITE
www.blackwidowbows.com
516
517
569