TORO Network VP Satellite User Guide - Reinders.com

Power-Up ModeWhen the VP satellite is powered-up, it will initiate a self-diagnostic test automatically. The user can not override orselect this mode. If a problem is detected during the self-diagnostic, it will be indicated on the display.After the diagnostic test is done, four lines of information will be displayed on the screen. Each of the four linesprovides different status information. These status information can not be edited. The information are as follows:Line 1: [Day/Date/Time]Line 2: [Satellite Model] [Firmware Version]Line 3: [I/O detected]Line 4: [The status of the self-test]Power-Up Display ExampleW e d 0 3 / 2 4 / 0 1 1 0 : 4 7 a mV P 1 0 0 0 R e v : 0 1 . 0 0D e t e c t : 3 2 s t a , 0 6 s e nS t a t u s : P a s s e dRun ModeThe satellite is placed in the RUN mode for automatic operation. When in the RUN mode, the satellite will executewatering programs automatically, activating stations according to the scheduled irrigation programs. The satelliteparameters and programs can not be reviewed or edited while in the RUN mode.Screen NotationsCharacterRepresentation when displayed% Not all watering parameters are 100% adjusted.Pxx Program number ‘xx’ (i.e., P12 = program 12)ManManual ProgramEach line on the display provides different information during the RUN mode. The information are as follows:Line 1: [Day/Date/Time]Line 2: [Satellite address] [Alert if present]Line 3: [The next scheduled run time and program number -OR- The number of programs/stations running]Line 4: [detail - press the down arrow for more information]RUN Mode Example 1 - No station currently running (watering.) The next scheduled watering is at 7:45pm. The “%”symbol indicates that the satellite has been percent adjusted from 100%.W e d 0 3 / 2 4 / 0 3 1 0 : 4 7 a mS a t # 1 - 1 1 8 %N e x t s t a r t a t 7 : 4 5 p m