Solar energy systems & prices - Solution Solartechnik GmbH

Wellness solution
the healthy shower
SOLution FRESH WATER UNIT FRED
SOLution LAYER LOADING UNIT ADELHEID
30
Fresh water heating
Hygienic hot water thanks to heating which is
ensured by the throughput principle
Short installation time through pre-assembled units
SOLution fresh water unit for hygienic hot water heating ensured by the
throughput principle by means of plate-type heat exchanger and proportional
controller. Pre-assembled hydraulic station including heat exchanger, control
valve, pump, stainless steel tubes and stainless steel body, ready to plug in;
Anti calcification guarantee 100°C/212F buffer temp., 50°C/122F WW tap temp.
FRE30 Fresh water unit for flow rate up to 30 l/min
wired and ready to plug in
1.422,00
FRE30Z Fresh water unit for tapping quantity up to 30 l/min
with circulation pump including time-automatic and
thermostat deactivation
1.887,00
BWM hot water mixer 3/4“ 120,00
Units with higher capacity available on request
Layer loading
Excellent solar utilisation thanks to low flow operation
Optimal storage loading through external
reversing switch
Short installation time thanks to pre-assembled units
Layer loading unit for loading the buffer storage tank in 2 levels.
Consisting of: solar plate-type heat exchanger for solar energy systems up
to 40 m 2 , primary and secondary pump, reversing valve, safety installations,
rinsing equipments and fittings.
SLE40 Pre-assembled hydraulic station for layer loading 1.693,00
including insulation
Storage management:
solar panels
heating
boiler
layer loading storage tank
fresh water
heating
principle scheme
www.sol-ution.com
hot water
cold water
FRE30
FRE30Z
SLE40
The optimal speed control can be
achieved in connection with the
electrical current control unit
UVR63S or UVR64S.