Ferrites and accessories, EP20, Coil former - Epcos

More documents

Recommendations

Info

Ferrite accessoriesCoil former EP20Preliminary dataEP20/10-1 PTHCoil formerMaterial:PMC thermosetting plastic (UL 94 V-0)Phenolic T-355J [E304813], CHANG CHUN CHEMICAL CO LTDSections A N l N A R value Terminals Ordering codemm² mm µ1 35.3 41.1 40.0 10 B65848E1010D001SMP IN FER D PD 2007-02-01 Page 2 of 4
Ferrite accessoriesCoil former EP20Preliminary dataEP20/10-1 PTHCautions and warningsMechanical stress and mountingFerrite cores have to meet mechanical requirements during assembling and for a growing number ofapplications. Since ferrites are ceramic materials one has to be aware of the special behavior undermechanical load.As valid for any ceramic material, ferrite cores are brittle and sensitive to any shock, fast changing ortensile load. Especially high cooling rates under ultrasonic cleaning and high static or cyclic loads cancause cracks or failure of the ferrite cores.For detailed information see Data Book 2007, chapter “General – Definitions, 8.1”.Effects of core combination on AL valueStresses in the core affect not only the mechanical but also the magnetic properties. It is apparentthat the initial permeability is dependent on the stress state of the core. The higher the stresses are inthe core, the lower is the value for the initial permeability. Thus the embedding medium should havethe greatest possible elasticity.For detailed information see Data Book 2007, chapter “General – Definitions, 8.2”.Heating upFerrites can run hot during operation at higher flux densities and higher frequencies.NiZn-materialsThe magnetic properties of NiZn-materials can change irreversible in high magnetic fields.Processing notes– The start of the winding process should be soft. Else the flanges may be destroid.– To strong winding forces may blast the flanges or squeeze the tube that the cores can nomore be mount.– To long soldering time at high temperature (>300 °C) may effect coplanarity or pinarrangement.– Not following the processing notes for soldering of the J-leg terminals may cause solderabilityproblems at the transformer because of pollution with Sn oxyd of the tin bath or burnedinsulation of the wire. For detailed information see Data Book 2007, chapter “Processingnotes, 2.2”.– The dimensions of the hole arrangement have fixed values and should be understood as arecommendation for drilling the printed circuit board. For dimensioning the pins, the group ofholes can only be seen under certain conditions, as they fit into the given hole arrangement.To avoid problems when mounting the transformer, the manufacturing tolerances forpositioning the customers’ drilling process must be considered by increasing the holediameter.SMP IN FER D PD 2007-02-01 Page 3 of 4
Page 1: Ferrite accessoriesCoil former EP20

Ferrites and accessories, EP20, Coil former - Epcos

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?