PNEG-258 -Scattergrain Grain Spreader - David Manufacturing Co.

5. InstructionsAdjustment for Bin FillLarge Bin36" Diameter and GreaterSmall Bin24" Diameter and LessRef # Part Type Operation/Procedure Operation/Procedure1 Spreader Blade TiltDecrease (flatten)/loosen U-bolts andpivot the blade to horizontal. Alwaysrefer to single diverter side as gauge.Increase/loosen U-bolts and pivot theblade (single diverter side) upward.2SpreaderDiverterSingle SideDual SideDecrease (center filling)/loosen boltsand rotate diverter clockwise.Decrease (center filling)/loosen boltsand rotate diverters clockwise to directflow in line with grain stream.Increase (center filling)/loosen bolt androtate diverter counterclockwise.Increase (center filling)/loosen bolt androtate diverters counterclockwise todirect flow across grain stream.3 Blade Extension Tilt4 Damper OpeningIncrease/loosen bolt and pivot theextension upward to maximumallowance in slotted hole.Decrease (center filling)/loosenbolts and pivot dampers to nearlyclosed position.Remove blade extension.Increase (center filling)/loosen boltsand pivot dampers to almost fullyopen position.1. Rotation is always viewed from top of the unit looking down on to the blade.2. Be sure to fully tighten all bolts after each adjustment is made.3. These adjustments describe the requirements for both extremes of bin sizes. For bin sizes between24" and 36" in diameter, start with intermediate adjustments and vary slightly as required to reachdesired results.PNEG-258 Scattergrain Grain Spreader 15