im 1925 tri-blade - Bomford Turner

More documents

Recommendations

Info

1925 6. OPERATION 0505To Place The Tri-Blade 4000 In The Transport PositionWARNINGAvoid injury. Ensure there are no bystanders between tractor and machine when couplingmachine to the tractor.abcdeFit wheel brackets at end of deck and secure with pins and linch pins.Lower machine to the ground, stop engine and disconnect PTO and store in a safe placeUncouple machine from tractor and carefully drive tractor forward.Fit drawbar to the bracket provided at the opposite end of the deck and secure with pins and linch pins.Couple tractor to drawbar.6 - 4
1925 7 MAINTENANCE 0405PTO ShaftThe PTO shaft is of the normal agricultural type and fitted with a slip clutch at the gearbox end. Spareskits comprising the spider, needle bearings, circlips etc are available from your dealer.Some routine maintenance is needed to ensure a trouble free life for the shaft as detailed below:-a. Grease PTO shaft sliding tubes daily.b. Grease universal joints at both ends of shaft daily. Do not over grease as it could cause overheatingand damage to the bearing seals.c. Check joint bearing journals for roughness or slackness.d. Check the PTO guard is in good condition and if not replace.e. Ensure the anti-rotation check chains are securely attached.Slip ClutchIf the machine is to be stored outside for more than 30 days and exposed to rain or humid conditions it isrecommended that the PTO shaft and slip clutch assembly are removed and stored in a dry place.It is important that the clutch slips when an obstacle or load heavier than the clutch setting isencountered. Therefore, if the machine sits outside longer that 30 days and is exposed to rain and/orhumid air, it is important to make sure that the clutch lining plates are not rusted/corroded together.Before using the machine.7 - 1
Page 1: IM 1925TRI-BLADETri-Blade 3000Tri-B
Page 4 and 5: 1925 2. TECHNICAL DATA 0505Tractor
Page 6 and 7: 1925 3. GENERAL ARRANGEMENT 05052 3
Page 8 and 9: 1925 4. SAFETY 0405DANGER!DANGER!DA
Page 10 and 11: 1925 5. INSTALLATION 0405Fitting Ma
Page 12 and 13: 1925 6. OPERATION 0405Pre Start Che
Page 16 and 17: 1925 7 MAINTENANCE 0405To check tha
Page 18 and 19: 1925 MAINTENANCE 0405WARNINGAvoid p
Page 20 and 21: 1925 REPLACEMENT PARTS 0405MAINFRAM
Page 26 and 27: 1925 REPLACEMENT PARTS 0405CHAIN GU
Page 28 and 29: 1925 REPLACEMENT PARTS 0405CHAIN GU
Page 30 and 31: 1925 REPLACEMENT PARTS 0306DRIVE AS
Page 32 and 33: 1925 REPLACEMENT PARTS 0306BLADE AS
Page 34 and 35: 1925 REPLACEMENT PARTS 0405WHEEL AS
Page 40 and 41: 1925 REPLACEMENT PARTS 0505TRANSPOR
Page 42 and 43: 1925 REPLACEMENT PARTS 0306TRANSPOR
Page 44 and 45: 1925 REPLACEMENT PARTS 0405DECALS13

im 1925 tri-blade - Bomford Turner

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?