L I G H T I N G L A N D S C A P E - Lumascape

L U M A S C A P EH E A D O F F I C E & F A C T O R Y48Lumascape Head Office and Factory38-44 Enterprise Street,Cleveland QLD Australia 4163Lumascape Lighting Industries and its affiliates worldwide are not responsible forinadequate use of a product or a misapplication of one of their light fittings. All productsare subject to specific installation instructions either supplied within each product box orcarton or available on our website or through the wholesaler or the manufacturer'srepresentative, all site application or installation must reflect these procedures otherwisethe product warranty will be considered void or will not take effect. All warranty claimsare subject to manufacturer's review and acceptance, all claims are limited to the repairor the replacement of the products only and do not include any labour or transportationcharges. Product must be sent back to the factory or discarded as per manufacturer'sinstructions once the claim is acknowledged by Lumascape.Power tools shall not be used to tighten or assemble products. Any damage claim orproduct failure associated to this matter will be promptly dismissed or rejected.All installations shall be performed with respect with the local, state and countryelectrical code (N.E.C. etc..). All items must be properly grounded and all installationsshould be performed by a professional electrician and or a duly licensed contractorcarrying proper liability insurance. All information supplied by the manufacturer'srepresentative shall be reflected in the catalogue or verified with the factory if it deviatesfrom the primary intended use of a specific product or the product limitations.All installations matters and failures related to installation matters will be the installer'sresponsibility and will remain so throughout the life of the product. Lamp wattages andmatching replacement parts must be respected throughout the product life.Lumascape products have been factory tested, documented in the product manual and,or listed by governing safety bodies or public safety agencies to comply with rules andregulations in effect at the time of registration. Product must therefore be used withinthese parameters and selection must be exercised accordingly by consultants andlighting professionals to extend and preserve public safety during the installation andafter.All warranty claims must be returned to Lumascape Lighting Industries for assessment.There is no warranty offered on lamps other than lamp manufacturers warranty if any.Lumascape Lighting Industries accepts no responsibility for damage to any ancillaryequipment or inconvenience caused by the failure of our products. Lumascape LightingIndustries reserves the right to alter fittings or specifications at any time.C 2003 All rights reserved.No part of this publication may be reproduced, copied or transmitted in any form by anymeans graphic, electronic or mechanical (including photocopying, recording, taping or byany information storage and retrieval system) without prior permission in writing of thepublisher Lumascape Lighting Industries Pty LtdABN 21 010 572 773.