TC35i AT Command Set

TC35i AT Command Set2.9 AT+CFUNsAT+CFUN?+CFUN: 1Indicates that ME has entered full functionality mode.EXAMPLE 3To stop CYCLIC SLEEP mode and return to full functionality:AT+CFUN?+CFUN: 5OKAT+CFUN=1OKRemember that this approach is not applicable to the NON-CYCLIC SLEEP mode (since the serial interfaceis disabled). The NON-CYCLIC SLEEP mode ends with the first wake-up event.EXAMPLE 4To reset and restart the ME:AT+CFUN=1,1 or alternatively, AT+CFUN=0,1 or 5,1 or 6,1 or 7,1 or 8,1OK^SYSSTARTThe ^SYSSTART URC confirms that the ME has been rebooted. Notethat ^SYSSTART appears only if AT+IPR ≠ 0. If the ME is in autobaudmode, it is recommended to wait 3 to 5 seconds before entering the firstAT command. Remember to enter the SIM PIN after restart.2.9.1 Wake up the ME from SLEEP modeA wake-up event is any event that causes the ME to draw more current. Depending on the selected mode, thewake-up event either switches the SLEEP mode off and takes the ME back to full functionality AT+CFUN=1, oractivates the ME temporarily without terminating the selected SLEEP mode.Definitions of the state transitions described in Table 2.3:• Quit: ME exits SLEEP mode.• Temporary: ME becomes active temporarily for the duration of the event and the mode-specific follow-up timeafter the last character was sent or received on the serial interface.• No effect: Event is not relevant in the selected SLEEP mode. The ME does not wake up.Table 2.3:EventWake-up events in NON-CYCLIC and CYCLIC SLEEP modesSelected mode:=0Selected mode:=5 or 6Selected mode:=7 or 8Ignition line No effect No effect No effect/RTS0 Quit No effect (RTS is onlyused for flow control)Unsolicited Result Code(URC)Incoming voice or datacallAny AT command (incl.outgoing SMS, voice ordata call)Incoming SMS (AT+CNMIis set to 0,0 (this is thedefault setting)Incoming SMS (AT+CNMIis set to 1,1)No effect (RTS is onlyused for flow control)Quit Quit TemporaryQuit Quit TemporaryNot possible (UART disabled)TemporaryTemporaryNo effect No effect No effectQuit Quit TemporaryTC35i_ATC_V03.01 Page 39 of 379 9/9/05Confidential / Released