English - Kohler Engines

NOTE:Upon start-up, a metallic ticking mayoccur. This is caused by hydraulic lifterleakdown during storage. Run the enginefor 5 minutes. The noise will normallycease in the first minute. If noisecontinues, run the engine at mid-throttlefor 20 minutes. If noise persists, take theengine to your local Kohler Service outlet.b. For engines equipped with a shutdownsolenoid: Position the throttle control somewherebetween half and full throttle; then stop the engine.BatteryA 12 volt battery is normally used. Refer to the operatinginstructions of the equipment this engine powers forspecific battery requirements.NOTE:If the engine develops sufficient speed todisengage the starter but does not keeprunning (a false start), engine rotationmust be allowed to come to a completestop before attempting to restart theengine. If the starter is engaged while theflywheel is rotating, the starter pinion andflywheel ring gear may clash, resulting indamage to the starter.If the starter does not turn the engine over, shutoff starter immediately. Do not make furtherattempts to start the engine until the condition iscorrected. Do not jump start using another battery(refer to “Battery”). See your Kohler EngineService Dealer for trouble analysis.3. For a Cold Engine – Gradually return the chokecontrol to the “off” position after the engine startsand warms ups.The engine/equipment may be operated duringthe warm up period, but it may be necessary toleave the choke partially on until the engine warmsup.4. For a Warm Engine – Return choke to “off”position as soon as engine starts.Stopping1. Remove the load by disengaging all PTOattachments.2a. For engines without a shutdown solenoid:Move the throttle to the ‘‘slow’’ or ‘‘low’’ idleposition. Allow the engine to run at idle for 30-60seconds; then stop the engine.If the battery charge is not sufficient to crank the engine,recharge the battery (see page 12).OperatingAngle of OperationThis engine will operate continuously at angles up to25°. Check oil level to assure crankcase oil level is atthe “F” mark.Refer to the operating instructions of the equipment thisengine powers. Because of equipment design orapplication, there may be more stringent restrictionsregarding the angle of operation.NOTE:Do not operate this engine continuously atangles exceeding 25° in any direction. Enginedamage could result from insufficientlubrication.CoolingNOTE: If debris builds up on the grass screen or othercooling air intake areas, stop the engineimmediately and clean. Operating the enginewith blocked or dirty air intake and coolingareas can cause extensive damage due tooverheating.WARNING: Hot Parts!Engine components can get extremely hot fromoperation. To prevent severe burns, do not touch theseareas while the engine is running–or immediately after itis turned off. Never operate the engine with heatshields or guards removed.Engine SpeedNOTE: Do not tamper with the governor setting toincrease the maximum engine speed.Overspeed is hazardous and will void theengine warranty.Maintenance InstructionsMaintenance, repair, or replacement of the emission control devices and systems, which are being doneat the customers expense, may be performed by any non-road engine repair establishment or individual.Warranty repairs must be performed by an authorized Kohler service outlet.WARNING: Accidental Starts!Disabling engine. Accidental starting can cause severe injury or death. Before working on the engine or equipment,disable the engine as follows: 1) Disconnect the spark plug lead(s). 2) Disconnect negative (-) battery cablefrom battery.7