2009 Sundance PreDelivery Guide (All Models) - Champagne Spas

Important: When installed in the United States, the electrical wiring of this spamust meet the requirements of the National Electric Code (NEC) and any applicable stateor local codes. The electrical circuit must be installed by an electrical contractor ANDapproved by a local building/electrical inspector.Power Configurations for 880 Capri Models (North America, 60Hz)This section describes the power configuration choices (Standard 50 Amp, and Alternate 40AMP) for Capri hot tub models.NoteWire size must meet NEC recommendations and is determined bymaximum current draw and length or run.Important: All of the alternative electrical configurations require a qualified technician toperform minor circuit board modifications. To avoid damage to the spa, do not activatepower to the spa until these modifications have been made. We recommend Square-D orCutler Hammer circuit breakers.Config. #1Config. #2Standard 50A Configuration(factory setting)• 240 VAC/50A 3-wire configuration(2 hots and a ground)• 50A dual-pole GFCI breaker (hardwired only)• Maximum electrical current drawof 40AAlternate 40A Configuration(For homes where 240 VAC/50A isunavailable).• 240 VAC/40A 3-wire configuration(2 hots and a ground)• 40A dual-pole GFCI breaker (hardwired only)• Maximum electrical current drawof 26AIn this Standard 50A configuration, the heaterdoes run if the jets pump and blower are running.If the home’s electrical system does not have thefull 240 VAC/50A power available, the spa maybe connected to a 240V/40A power source after aqualified electrician makes a minor circuit boardmodification.In this configuration, the heater yields thesame rapid temperature rise as in the 50Aconfiguration, but does not run at the same timeas either of the jets pumps or when the blower isrunning.13