m.e.c. timingÂ® cxp cxa - A ZETA Gomma

More documents

Recommendations

Info

The type CXP is in polychloroprene with insert of plaited glass fibres.The type CXA has got the mixture like the CXP while the insert are in aramid.Pitch available : 3 – 5 – 8 – 14 M for CXP8 – 14 M for CXAClassification of M.E.C. TIMING BELT ® HTD ® CXP ® and CXA ®The belts are available in the following pitch distinguished by commercial names shown aside and the followingstandard widths.PitchcodeCommercialnamePitchmmNotch thicknessmmTot.thicknessmmStandardWidthsmm567833 M CXP5 M CXP8 M CXP14 M CXP8 MS CXA3581481,22,13,46,13,42,43,65,6105,66-9-159-15-2520-30-50-8540-55-85-115-17020-30-50-85Specification of M.E.C. TIMING BELT ® HTD ® CXP ® and CXA ®The M.E.C. TIMING BELT ® HTD ® CXP and CXA are distinguished by pitch length in mm , pitch in mm, width in mm.Example:A belt with a pitch length in mm 960 mm or 1120, the pitch 8 mm and the width 50mm is indicated as follows :960 8M 50 CXP or 1120 8M CXA
SYNCHRONOUS HTD ® , CXP and CXA BELTSTOLERANCESTable 1 – Standard tolerances on the width of the belts TIMING BELT HTD ® CXP and CXAWidth of the belt(mm)Tolerance for length from (mm)Up to 838 from 838 to 1676 over 1676Table 2 – Standard tolerances on the thickness of the belts TIMING BELT HTD ® CXP and CXATypeCXP and CXAThickness (mm)TolerancesDegree1 Degree 2 StandardTable 3 – Standard tolerances on development of the belts TIMING BELT HTD ® CXP and CXAWidth of the belt(mm)Tolerance on the development(mm)Tolerance on the wheelbase(mm)For special uses, like for example fixed wheelbase transmissions, that require different tolerances from those standard,ask for technicians advices.
Page 1: M.E.C. TIMING BELT ® HTD ® CXP ®
Page 5 and 6: P265-5M 265 53295-5M 295 59300-5M 3

m.e.c. timingÂ® cxp cxa - A ZETA Gomma

Create successful ePaper yourself

Delete template?

Save as template?