loctite 222 threadlocker - All Fasteners

MATERIAL SAFETY DATA SHEETSECTION 4.Ingestion:Skin:Eyes:Inhalation:FIRST AID MEASURESIf swallowed, do not induce vomiting. For advice, contact a Poisons InformationCentre (Phone 13 11 26) or a doctor.Remove contaminated clothing and wash affected areas with plenty of water. Ifirritation, redness or blistering occurs, seek medical attention.Hold eyes open and flush with water for at least 15 minutes. If irritation develops,seek medical attention.If inhaled, remove from contaminated area. For all but the most minorsymptoms, arrange for patient to be seen by a doctor.Advice to doctor: Treat symptomatically.First Aid facilities: Eye wash and normal washroom facilities.SECTION 5.FIRE FIGHTING MEASURESSuitable extinguishing media: Use foam, dry chemical or carbon dioxide.Hazards from combustion products: In a fire, it will burn. Under fire conditions, it can releaseoxides of carbon, oxides of nitrogen and noxious fumes.Precautions for fire fighters and special protective equipment: If there is a risk of exposure toproducts of combustion, fire-fighters should wear self-contained breathing apparatus.SECTION 6.ACCIDENTAL RELEASE MEASURESWear protective gloves, chemical goggles and safety boots. For small spills, wipe up residue with acloth. For large spills, contain and collect spillage with inert absorbent materials (e.g. sand, earth,vermiculite). Transfer to sealable containers suitable for storing spilled material. Flush areas incontact with material with adequate warm soapy water to render the area safe for human contact.Note: Residues are slightly water soluble. Do not contaminate watercourse. Dispose of solid residuesin waste disposal area in accordance with relevant State and Federal requirements.SECTION 7.HANDLING AND STORAGESafe Handling: Observe recommendations made under SECTION 8. EXPOSURECONTROLS/PERSONAL PROTECTION. Use in a well ventilated area. Avoid breathing vapour.Storage: Store indoors in a cool, dry and well ventilated area. Keep containers sealed when not inuse. Store in original containers away from heat, sparks and open flames. Store at or below 38°C.SECTION 8.EXPOSURE CONTROLS / PERSONAL PROTECTIONNational exposure standards: TWA: 10mg/m³ as propylene glycol.Engineering controls:None required under normal conditions of use, but if vapour or mistis being generated, use a local mechanical exhaust system.Personal protective equipment: Avoid contact with skin and eyes. Wear neoprene or butyl rubbergloves and safety glasses with side shields. Use with adequate ventilation. If inhalation risk exists,wear a respirator complying with the requirements of AS 1715 and AS 1716.SECTION 9.PHYSICAL AND CHEMICAL PROPERTIESDATE OF MSDS: 02.11.05 REVISION OF: July 2001 IDH NO: -Page 2 of 4 PROPRIETARY PRODUCT: LOCTITE 222 THREAD LOCKER