Xray XB8 - Ashford Hobby

More documents

Recommendations

Info

FINAL ASSEMBLYCut the silicone tube depending on engine and muffler.Use the plastic clips to hold the tubes togetherThe fuel filter has a smallhole that fits into notch on thecomposite holder to prevent thefilter from turning freelyUse the fueltubing holderswhere neccessary902308SH M3x8Always use air filter oilOIL322
THROTTLE LINKAGE ADJUSTMENNeutral (Idle)0.5mmADJUST INDIVIDUAL LINKAGES SEPARATELY TO AVOIDINTERFERING WITH THE OPERATION OF THE OTHERSEngine idlingcca 1mm* Turn on the transmitter and receiver and set the engine control servo trim to the neutral position.* Adjust the idle adjustment screw on the carburetor to open approx. 1mm.* Adjust both the throttle linkage and brake linkages accordingly.* DO NOT adjust the linkage with the engine running.Idling Adjustment Screw.Use to adjust the idle setting of the carburetor.Do not allow carburetor to close to less than 1mm.High throttle* Adjust the servo-horn mounting position for the carburetor to open fully.* Change the pivot mounting position on the servo horn in case the carburetor is not opening fully or if it is opening excessively.Or if available on the transmitter, adjust the throttle high end point.BrakeBrake adjusting knobs:Upper linkage - rear brakeLower linkage - front brakeEngine idlingcca 1mm* Adjust the adjustable collars so the brakes work smoothly.* If the brakes apply too much or not enough, adjust the adjustable collars accordingly. Or if available on the transmitter, adjust the brake endpoint.* To tighten brakes, turn collar to thread brake rod INTO pivot.* To loosen brakes, turn collar to thread brake rod OUT of pivot.33
Page 2 and 3: INTRODUCTIONThe XRAY XB8 is a moder
Page 4 and 5: SYMBOLS USEDPart bags usedAssemble
Page 6: 1. FRONT & REAR DIFFERENTIAL3550609
Page 9 and 10: CENTER DIFFERENTIALOIL940816BB 8x16
Page 11 and 12: REAR TRANSMISSION355600901504940816
Page 13 and 14: 4. REAR SUSPENSION35352035355090231
Page 15 and 16: 5. FRONT SUSPENSION909369352320 352
Page 17 and 18: FRONT SUSPENSION902305SH M3x5L=RDIS
Page 19 and 20: FRONT & REAR ASSEMBLY902308SH M3x8S
Page 21 and 22: STEERING903310SFH M3x10940610BB 6x1
Page 23 and 24: CENTER DIFF & BRAKE901304SB M3x42 m
Page 25 and 26: 11~11.2 mmFUEL TANK & ENGINE3x12Tig
Page 27 and 28: RADIO CASE902308SH M3x8KO PROPO3x10
Page 29 and 30: SHOCK ABSORBERS1. Install the pivot
Page 31: FINAL ASSEMBLY3x22REAR SUSPENSION90
Page 35 and 36: Preparing to operate the engine•
Page 37 and 38: XB8 SET-UPRear Roll CenterYou can r
Page 39 and 40: XB8 SET-UPServo Saver PreloadAdjust
Page 41 and 42: XB8 SET-UP❍ TOEYou can adjust dif
Page 43 and 44: XB8 SET-UP❍ REAR WINGAdjust the p

Xray XB8 - Ashford Hobby

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?