2009 GMC Savana Owner Manual

Replacing the Rear Seats{ CAUTION:A seat that is not locked into place properly canmove around in a collision or sudden stop. Peoplein the vehicle could be injured. Be sure to lock theseat into place properly when installing it.{ CAUTION:A safety belt that is improperly routed, not properlyattached, or twisted will not provide the protectionneeded in a crash. The person wearing the beltcould be seriously injured. After raising the rearseatback, always check to be sure that the safetybelts are properly routed and attached, and arenot twisted.1. Position the seat into the open slots in both rails.Push the seat forward in the rail, hooking bothseat bases onto the pins inside of the rails.2. Locate the hole in the rail to install the locking pins atthe rear of the seat base. If the vehicle has floormats, pull the flap that has been cut into the mat.3. Insert the locking pins into the seat base and pushthe seat to line up the pins with the base.On a three passenger seat, the pin with the blackcap marked “R” must be installed on the passengerside and the pin with the gray cap marked “L” onthe driver side.On a four passenger seat, the pins marked “R”must be installed on the half of the seat onthe passenger side. The pins marked “L” must beinstalled on the half of the seat on the driver side.1-8