PDS N4.2 P110-5000 UV-SpeedPrime - BAPS

More documents

Recommendations

Info

UV-SpeedPrimePRODUCTSP110-5000 UV-SpeedPrimeP273-5255 Cleaner for UV PrimersP273-5260 Cleaner for UV PrimersTHESE PRODUCTS ARE FOR THE PROFESSIONAL PAINTING OF AUTOMOTIVE VEHICLES ONLY2
PROCESSMIX RATIOUV-SpeedPrime is supplied Ready-for-Use.Shake aerosol well before use.APPLICATIONApply 4-5 continuous passes over repairs at a spray distance of8-10 inches (20-25 cm) to achieve a film build of 3-5 mils.DRYINGCuring time for UV-SpeedPrime is 2 minutes using an approvedUV curing lamp.Apply light from UV curing lamp at a distance of 8-10 inches (20-25cm) from UV-SpeedPrime with a footprint of approximately12” x 12” at 10 inches.10"12"CLEANINGUsing P273-5255/5260 (Cleaner for UV Primers), thoroughly clean therepair area to remove uncured surface residue and overspray. The entirearea should be well cleaned and wiped dry before sanding.Note: Separate cloths should be used for application and removal ofP273-5255/5260.SANDINGSand the cured UV Primer with the following grades:Wet:Dry:P600 or Finer: Single LayerP800 or Finer: BasecoatsP320 or Finer: Single LayerP360 or Finer: BasecoatsNote: If surface is not thoroughly cleaned, some disc clog may be noticed. If thisoccurs, change discs and continue sanding.3
Page 1: PDS N4.2July 2005P110-5000UV-SpeedP
Page 6: UV-SpeedPrimeGENERAL PROCESS NOTES(

PDS N4.2 P110-5000 UV-SpeedPrime - BAPS

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?