13.07.2015 Views

Vulcathene technical brochure - Plastic Systems

Vulcathene technical brochure - Plastic Systems

Vulcathene technical brochure - Plastic Systems

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

<strong>Vulcathene</strong>Chemical Waste Drainage System Pipe, Bench Products & Ancillaries603 Running TroughFabricated to customers specific requirements the running trough ismanufactured with 3mm thick walls and is supplied complete with wasteoutlet - as specified - and supporting framework.Cat. No. 603A127mmB210mmC1 1 / 2 " BSP 2" BSPW681 Dilution Recovery TrapEasily emptied, by unscrewing the base from the trap, this large capacity antisiphonicdilution recovery trap has a 76mm liquid seal and holds 2.3 litres.The 1 1 /2" BSP inlet includes a loose nut coupling for connection to a wasteoutlet or drip cup tail. The trap is supplied with a nut and olive to enable it tobe ‘P’ trap configured for 38mm pipe. The addition of a W291 38mm bendwill change the configuration to an ‘S’ trap.Cat. No. W681A86mmB325mmC270mmD133mmE1 1 / 2 " Mechanical threadF1 1 / 2 " BSPgms 480Product Code V1068101W691 Dilution Recovery Trap (Glass Base)The 691 trap has a total capacity of 2.3 litres and a 76mm liquid seal.The clear base of heat resistant, borosilicate glass makes this an ideal choicefor use in waste systems which have to cope with large quantities of solidwaste matter. The trap allows the volume of solids collected to be quicklyassessed and, where necessary, cleared, before they can cause any damageto the system. It also allows the identification and recovery of valuable solids.In order to remove the dilution chamber from the trap body, the glass unitshould be unscrewed complete with its flange assembly. The 1 1 /2" BSP inletincludes a loose nut coupling for connection to a waste outlet or drip cup tail.The trap is supplied with a nut and olive to enable it to be ‘P’ trap configuredfor 38mm pipe. The addition of a W291 38mm bend will change theconfiguration to an ‘S’ trap.When installed it is important to support the underside of the trap (at least76mm above the floor) to avoid weight strain on the pipework andconnections.Cat. No. W691A86mmB314mmC254mmD229mmE1 1 / 2 " Mechanical threadF1 1 / 2 " BSPgms 2390Product Code V106910115

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!