Acid Test Kit (for Polyol Ester Oil) - media - DiversiTech

More documents

Recommendations

Info

MATERIAL SAFETY DATA SHEETAcid Test Kit (for Polyol Ester Oil)3. COMPOSITION / INFORMATION INGREDIENTSIngredient CAS No EINECS No. % Hazard Symbol Risk PhrasesIsopropanol 67-63-0 200-661-7 90-100 Xi, F R11, 36, 67See Section 15 for an explanation of Risk Phrases4. FIRST-AID MEASURESInhalation: Obtain medical attention for all cases of over-exposure.Swallowing: If patient is fully conscious, give two glasses of water. Induce vomiting. Obtain medical attention.Skin: Wash skin with soap and water for at least 15 minutes.Inhalation: Remove to fresh air; Give artificial respiration if not breathing;If breathing is difficult oxygen may be given by qualified personnel; obtain medical assistance is discomfort persists.Eye Contact: Flush eyes with water for at least 15 minutes. Obtain medical assistance.5. FIREFIGHTING MEASURESExtinguishing media: Apply alcohol-type or all-purpose foam by manufacturer’s recommended techniques for large fires. Usecarbon dioxide or dry chemical media for small fires.Special Fire Fighting Procedures: Use water spray to cool fire-exposed containers and structures; Use water spray to dispersevapors - re-ignition is possible; Use self-contained breathing apparatus and protective clothing.Unusual Fire and Explosion Hazards: Vapors may travel to source of ignition and flash back. Vapors may settle in low orconfined spaces, or produce a floating fire hazard. Static ignition hazard can result from handling and use.6. ACCIDENTAL RELEASE MEASURESRemove contaminated clothing immediately. Remove unnecessary personnel from the area of the spill.Small spills can be wiped or soaked up. Large spills: Eliminate all ignition sources; ground all equipment; do not walk throughspill; stop spill if possible; prevent entry into sewers, confined spaces, etc.; use a vapor suppressing foam to reduce vapors;absorb spill with noncombustible matter and transfer to containers; use non-sparking tools to collect absorbed material. Refer tosection 11 for disposal information.7. HANDLING AND STORAGEFlammable material - keep away from heat, sparks, and flame; sudden releases of hot organic vapors ormists from process equipment operating at elevated temperature may result in ignitions without thepresence of obvious ignition sources. Avoid contact with eyes. Keep container closed. Use withadequate ventilation. Empty containers may retain residue. All containers should be disposed of in anenvironmentally safe manner, and in accordance with all governmental regulations. Keep this and allchemicals out of the reach of children. Wash thoroughly after handling. Vapors may settle in low orconfined areas.8. EXPOSURE CONTROLS /PERSONAL PROTECTIONExposure Limits:Isopropanol( CAS# 67-63-0)400 ppm TWA(OSHA) 980mg/m 3 TWA (OSHA) 2000ppm IDLH (NIOSH)Respiratory Protection (Specify Type): Use in a well-ventilated area. If vapors are generated andDiversiTech Corporation Chemical Emergency: P 800.255.39246650 Sugarloaf Parkway P 678.542.3600Duluth, GA 30097 Page 2 F 678.542.3700
MATERIAL SAFETY DATA SHEETAcid Test Kit (for Polyol Ester Oil)exceed the TLV, use of air-purifying respirators and follow respiratory program meeting OSHA 910.134and ANSI Z88.2 requirements.Ventilation: Local exhaust is recommended when used in enclosed areas.Protective Gloves: Neoprene, latex or other materials may be used if there is documented evidence ofcompatibility.Eye protection: Safety glasses (ANSI Z87.1) or approved equivalent as necessary to minimize eyecontact hazards.Other Protective Clothing: Neoprene aprons, overshoes, oversleeves or other impervious clothing asnecessary to minimize exposure.Work Hygienic Practices: Use proper industrial hygiene practices to minimize hazardous exposure.Wash hands after handling this material, and before eating or smoking.9. PHYSICAL AND CHEMICAL CHARACTERISTICSSolubility in water: Water miscibleAppearance: Clear purple liquidOdor: alcohol-likepH: Not available.Vapor Pressure: 33 mm Hg @ 20°CVapor Density: 2.1 (Air=1)Evaporation Rate: 1.7 (n-butyl acetate=1)Viscosity: 2.27 mPas @ 20CBoiling Point: 82°C @ 760 mmHgFreezing/Melting Point: -88 deg CSolubility in water: Miscible.Specific Gravity/Density: 0.78 (water=1)Flash Point: 12°C ( 54°F)Autoignition Temperature: 399 ° C ( 750° F)Explosion Limits: 2-12.7°C (vol) @ 93°CDecomposition Temperature: Not available.10. STABILITY AND REACTIVITYStability-StableConditions to avoid: NoneIncompatibility (Materials to avoid): Strong oxidizers, strong acids,Hazardous Decomposition or Byproducts: May evolve carbon monoxide, carbon dioxide if burnedHazardous Polymerization: Will not occur.11. TOXICOLOGICAL INFORMATIONLD50/LC50:CAS# 67-63-0:Draize test, rabbit, eye: 100 mg Severe;Draize test, rabbit, eye: 10 mg Moderate;Draize test, rabbit, eye: 100 mg/24H ModerateDraize test, rabbit, skin: 500 mg Mild;Inhalation, mouse: LC50 =53000 mg/m3DiversiTech Corporation Chemical Emergency: P 800.255.39246650 Sugarloaf Parkway P 678.542.3600Duluth, GA 30097 Page 3 F 678.542.3700
Page 5 and 6: MATERIAL SAFETY DATA SHEETAcid Test

Acid Test Kit (for Polyol Ester Oil) - media - DiversiTech

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?