Vehicle Emissions Inspection & Maintenance Rules & Regulations

More documents

Recommendations

Info

05.05.00 TSI TEST SEQUENCE - BMW/PEUGEOT/VOLVO/JAGUAR(ZF AUTOMATIC TRANSMISSIONS)Given the problems with the “ZF” automatic transmission, DPS prefers that the affected vehiclesbe tested at their dealerships. Accordingly, if the inspector enters an “A” (for automatic) for thetransmission type, and if the vehicle type and the vehicle make, model, and model year matchBMW/PEUGEOT/VOLVO/JAGUAR criteria, the TX 96 (TSI) analyzer displays the following message:BECAUSE OF THE POSSIBILITY OF TRANSMISSION DAMAGE TO THIS VEHICLE, DPSPREFERS THAT IT BE INSPECTED AT ITS DEALERSHIP. IF YOU STILL WISH TO PERFORMTHE INSPECTION, YOU MAY DO SO AT YOUR OWN RISK. PRESS “ENTER” TO CONTINUE.IF NOT, PRESS “ESC” TO ABORT THE TEST. (ENTER ABORT CODE 6)If the inspector chooses to continue testing this vehicle, the following message will be displayedwhen beginning the test sequence:BEFORE BEGINNING THE EMISSIONS TEST, MAKE SURE THE ENGINE IS AT NORMALOPERATING TEMPERATURE. IF NOT, THE VEHICLE SHOULD BE DRIVEN UNTIL IT IS. DONOT WARM THE ENGINE BY RAISING THE RPM ABOVE IDLE WHILE THE TRANSMISSIONIS IN PARK OR NEUTRAL.AFTER THE ENGINE REACHES NORMAL OPERATING TEMPERATURE, PUT THE TRANS-MISSION IN PARK AND TURN THE ENGINE OFF FOR 30 SECONDS. RESTART THEENGINE. AFTER THE ENGINE IS RUNNING, DO NOT MOVE THE GEAR SHIFT SELECTORTHROUGH THE FORWARD OR REVERSE GEARS BEFORE OR DURING THE TESTSEQUENCE. DO NOT EXCEED 2000 RPM.All 1984-87 BMWs with automatic transmissions, 1983-88 Volvo 740s with automatic transmissions,1984-89 Jaguar XJSs, and 1986-92 Peugeot 505s with automatic transmissions shall betested using this test sequence or the latest test sequence supplied by DPS.CONTACT YOUR LOCAL DEPARTMENT OF PUBLIC SAFETY VEHICLE INSPECTIONOFFICE IF YOU HAVE FURTHER QUESTIONS REGARDING ZF AUTOMATIC TRANSMIS-SIONS.5-1
05.10.00 1996 MERCEDES BENZOBDII INSPECTION PROCEDURESMercedes Benz advised that 1996 Mercedes Benz models: C220, C280, E320, S320, SL320, andC36AMG have the following problem:When the analyzerʼs diagnostic link cord is connected to the vehicleʼs diagnostic link connector(DLC - OBDII port), the check engine light will stay on causing the vehicle to fail. To avoidthis false failure, use the following procedure.When asked the second bulb check question (Did the MIL light turn off) choose “YES THE MILTURNED OFF”This procedure is to be used ONLY on 1996 Mercedes Benz models C220, C280, E320, S320, SL320,and C36AMG.If you have any questions, contact your DPS representative.5-2
Page 2 and 3: TABLE OF CONTENTSCHAPTER 1INTRODUCT
Page 4 and 5: 01.05.00 INTRODUCTIONThis manual pr
Page 6 and 7: CHAPTER TWOACCELERATION SIMULATION
Page 8 and 9: 02.05.00 ACCELERATION SIMULATION MO
Page 10 and 11: c. Commercial Motor Vehicles Requir
Page 12 and 13: 1. Rejection receipt,2. Emissions t
Page 14 and 15: 3.05.00 ON-BOARD DIAGNOSTICS II (OB
Page 16 and 17: Emissions Test. A motor vehicle req
Page 18 and 19: d. Vehicles operated exclusively by
Page 20 and 21: CHAPTER FOURTWO-SPEED IDLE (TSI)INS
Page 22 and 23: eceive an out-of-cycle emissions te
Page 24 and 25: after the rejection receipt is prin
Page 28 and 29: TEXAS DEPARTMENT OF PUBLIC SAFETYVE
Page 30 and 31: TEXAS DEPARTMENT OF PUBLIC SAFETYAi
Page 32 and 33: 05.25.00 ADMINISTRATIVE RULESTEXAS
Page 34 and 35: (32) VIR--refers to the Vehicle Ins
Page 36 and 37: (12) Inspection certificates issued
Page 38 and 39: (3) Parts Availability Time Extensi
Page 40 and 41: (B) possess equipment to perform th
Page 42 and 43: 05.25.02 RULE §23.95 Waiver for Lo
Page 44 and 45: 05.25.03 RULE §23.96 Emissions Ana
Page 46: GLOSSARY OF TERMS05.30.00Gas Audit

Vehicle Emissions Inspection & Maintenance Rules & Regulations

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?