Araldite CY 5995 100 Hardener HY 5996 87 Filler Silica flour 280 ...

Industrial hygieneMandatory and recommended industrial hygiene procedures should be followed wheneverour products are being handled and processed. For additional information pleaseconsult the corresponding Safety Data Sheets and the brochure "Hygienic precautions forhandling plastics products of Ciba Specialty Chemicals (Publ. No. 24264/e).HandlingprecautionsSafety precautions at workplace:protective clothingglovesarm protectorsgoggels/safety glassesrespirator/dust maskSkin protectionbefore starting workafter washingCleansing of contaminated skinClean shop requirementsDisposal of spillageVentilation:of workshopof workplaceyesessentialrecommended when skin contact likelyyesrecommendedApply barrier cream to exposed skinApply barrier or nourishing creamDab off with absorbent paper, wash withwarm water and alkali-free soap, then dry withdisposable towels. Do not use solventsCover workbenches, etc. with light coloredpaper Use disposable breakers, etc.Soak up with sawdust or cotton waste anddeposit in plastic-lined binRenew air 3 to 5 times an hourExhaust fans. Operatives should avoid inhalingvapors.First AidContamination of the eyes by resin, hardener or casting mix should be treatedimmediately by flushing with clean, running water for 10 to 15 minutes. A doctor shouldthen be consulted.Material smeared or splashed on the skin should be dabbed off, and the contaminatedarea then washed and treated with a cleansing cream (see above). A doctor should beconsulted in the event of severe irritation or burns. Contaminated clothing should bechanged immediately.Anyone taken ill after inhaling vapors should be moved out of doors immediately. In allcases of doubt call for medical assistance.Vantico Ltd..Electronic Polymers®Registered trademarkAPPROVED TOISO 9000 ffAll recommendations for use of our products, whether given by us in writing, verbally, orto be implied from results of tests carried out by us are based on the current states of ourknowledge. Notwithstanding any such recommendations the Buyer shall remainresponsible for satisfying himself that the products as supplied by us are suitable for hisintended process or propose. Since we cannot control the application, use or processingof the products, we cannot accept responsibility therefor. The Buyer shall ensure that thein-tended use of the products will not infringe any third party's intellectual property rights.We warrant that our products are free from defects in accordance with and subject to ourgeneral conditions of supply.25 July, 2000