Newport e500Ventilator

More documents

Recommendations

Info

Additional Data • Real Time Set Data: As the user adjusts V T , ƒ or V • while in Volume Control, the resultant set t I and I:E Ratio are displayed in real time in the Monitored Data window for 10 seconds. Adjusting t I or ƒ while in Pressure Control or Vol Target Pressure Control, the resultant set I:E Ratio is displayed in real time. • Ccomp: lights to indicate breathing circuit compliance compensation feature is enabled • tI > tE: lights to indicate an inverse ratio • Int Battery: lights when ventilator is operating on internal battery power • Ext Battery: lights when ventilator is operating on external battery power • Charging: lights to indicate that the ventilator is powered by AC and internal battery is recharging • Mains: lights when ventilator is supplied with AC power • Pressure Bar Graph: continuously displays pressure in the patient breathing circuit • Message Center Display: informational messages and alarm violation alerts are displayed • Hour Meter: displays amount of time ventilator has been powered on Audible and Visual Alarms Adjustable Alarms Low V • E (Exp. Minute Volume) High V • E (Exp. Minute Volume) Low Paw (Airway Pressure) High Paw (Airway Pressure) Tachypnea (High Rate) Automatic Alarms Patient Alarms: Operator Alarms: Back Up Vent: O2 Variability ± 0.07 of setting Apnea Proximal Line Disconnect Low Baseline Pressure High Baseline Pressure Sustained High Baseline Pressure Insp. Time Too Long Insp. Time Too Short I:E Ratio Inverse Violation Plimit Below Pbase Low Paw Below Pbase Vol Target Not Met [Alarm or Setting] Out of Range Indicator blinks and the Message Center displays "Back Up Ventilation" to indicate that the ventilator is supplying back up ventilation in response to a low V • E alarm O2 Sensor: O2 Sensor Bad / O2 Sensor Disconnect Gas Supply Alarms: Loss of One Gas Supply Loss of Both Gas Supplies Power Fail Alarms: Loss of AC Power Low Internal Battery Power Down Alarm: (audible only) Device Alert: Message Center displays miscellaneous messages indicating that the ventilator needs attention Alarm Silence: 120 sec (press and hold > 1 sec to enable Pre-Silence Alarm for disconnect) Alarm Reset: Clears visual indicators and messages Power Requirements 100 – 120 VAC 0.14 A max 50/60 Hz 220 – 240 VAC 0.07 A max 50/60 Hz • Internal Battery: provides a minimum of 30 minutes of complete ventilator function (excluding humidifier) when fully charged • External battery input: +12 to 15 VDC (± 10%), i.e. 12 VDC 7.2 Ah external battery provides a minimum of 30 minutes of operation Compliance • Complies with IEC 60601-1 with Amendments 1 and 1, C22.2 No 601.1-M90 and UL Std No 2601 • Type B Applied Parts • Rated battery voltage - 12 VDC • Class I electrical safety • Mode of operation - continuous operation (as per Clause 5.66) • IPXO rating (degree of protection against ingress of water) Special Features • Automatic Leak Compensation, Slope/Rise control, Expiratory (cycling off) Threshold control, Dual Control Breath Management (VTPC/VTPS) • Noninvasive ventilation: Compatible with mask ventilation for continuous or short term use. User may select NIV option via GDM for improved patient triggering and breath cyclingoff synchrony during noninvasive ventilation. • Pre-Silence Alarm: Press and hold Alarm Silence for more than one second to enable. Suspends ventilation while delivering continuous flow after a planned disconnect. • User Set Up Functions: Leak Test, Circuit Compliance Compensation (calculate and enable breathing circuit compliance compensation of flow/volume delivery), Altitude Compensation, Humidifier Selection, Communication Port Protocol, Violation Message Log • Bias Flow: Ventilator-set bias flow flushes exhaled CO2 and stabilizes temperature, humidity and baseline pressure in the patient breathing circuit. • O2 calibration: Automatic oxygen sensor calibration performed at software determined intervals. • Preset Vent Settings: Mode, breath type and settings can be preset without affecting current ventilator operation. • Biphasic Pressure Release Ventilation (BPRV): Enabling Open Exhalation Valve minimizes airway pressure excess due to cough or early exhalation while in Pressure Control. • Event History Log: Records the 600 most current parameter and alarm changes and alarm violations.
Dimensions e500 with GDM on Deluxe Cart: Width: 20.5 in (52 cm) at base Depth: 26 in (66 cm) at base Total Weight: 164 lbs. (75 kg) ship weight Total Height: 62.5 in (158.7 cm) e500 & GDM mounted Environmental Operating: Relative humidity: 10 to 95% Rh non-condensing Altitude: 0 to 13,124 feet (0 to 4000 meters) Pressure: 21 to 31 in. Hg (700 to 1060 hPa) Storage: Ambient temperature: -40 to 70 °C (-40 to 158 °F) Relative humidity: 10 to 95% Rh non-condensing Altitude: 0 to 18,000 feet (0 to 5500 meters) Pressure: 15 to 31 in. Hg (500 to 1060 hPa) Gas Supply Requirements Air and O 2 Supply Inlet Pressure: 30 to 90 psig, 50 psig nominal External Connections REMOTE ALARM: Normally open (NO) contact, nurse call or remote system must operate as a normally open system - 250mA @ 100VDC, allowable current at max. voltage between relay contact < .2 ohms, max. initial contact resistance GRAPHICS MONITOR: Input for Graphic Display Monitor (GDM) communication cable RS 232C: 9-pin D-shell, 38,400 baud. For use with central monitoring systems. CONTROL PANEL: Input for Control Panel Module (CPM) communication cable EXTERNAL ALARM SILENCE: Input for Newport external alarm silence cable EXTERNAL BATTERY 12 VDC: Input for an external battery Patient Circuit Connections Inspiratory and expiratory limb connectors: 22-mm OD Proximal tubing connector: 1/8 in. (0.32 cm) ID to fit 1/8 in. (0.32 cm) ID proximal pressure tubing Ordering the e500 Ventilator System The Newport e500 Ventilator System includes the Gas Delivery Unit, Control Panel Module, Graphics Display Monitor and Deluxe Cart. Order: E500-NC-US Standard accessories included: Built-in heated, permanent exhalation valve assembly Built-in oxygen sensor Support arm and breathing circuit hanger Air and oxygen hoses, 10 ft (3 m) with DISS fittings Air and oxygen inlet water traps Disposable bacteria filters (2) Disposable proximal inline filters (5) Operating Manual Additional accessories: Disposable insp. bacteria filters / cs 50 FLT1800Q-C Disposable exp. bacteria filters FLT1875P Proximal inline filter / 5 ea FLT1850DC Reusable adult patient breathing circuit PBC345A Reusable ped/infant breathing circuit PBC450A Disposable adult patient breathing ciruit / cs 20 51006600 Disposable ped/infant patient breathing circuit / cs 20 51006500 Disposable water trap WTR134P Printer cable CBL1900Q Adult test lung with restrictor LNG800P Preventive maintenance kit PMK500A Oxygen sensor R125P03-002 For current accessories and price information or to place an order contact your local distributor or Newport Customer Service Department. tel: 1.800.451.3111 ext. 282 fax: 1.949.548.3091 email: Customers@NewportNMI.com www.ventilators.com Specifications subject to change without notification.
Page 1 and 2: Newport e500Ventilator Technical Sp
Page 3: The Newport e500 Ventilator System

Newport e500Ventilator

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?