MS - MINI SBARRA 63 - 100 - 160A

Trunking components and
additional elements
Depending on the different installation requirements
Zucchini can provide various technical solutions:
a) 90° angles: available for carrying out changes of
direction both horizontally and vertically. There is
a quick connection, as with the straight elements.
standard IP40 degree of protection (IP55 with preinstalled
accessories);
b) T-type and X-type elements: available on request for
special applications;
c) flexible angle: available for 63A, 100A and 160A
capacities and allows changes of direction with
angles different, horizontal and vertical, from 90°;
d) straight elements with flame barrier (internal
+ external). These elements - used when it is
necessary to move through fire-resistant walls - have
been tested in laboratories (in compliance with DIN
Standards 4102-9 and EN 1366- 3) to confirm that, if
correctly installed, they can maintain the intrinsic
fire-resistant properties of the wall;
e) straight elements with bar lock: when the busbar is
installed vertically (riser mains) these elements are
equipped with a device that prevents the conductors
from sliding due to the weight of the portion of
column over it. This type of element is required at
about every 10 m of column.
End cap:
completes the
installation of the
lines and guarantees
the IP55 degree of
protection of the line.
Straight elements, with
tap-off outlets every
1000 mm from both
sides.
Wall suspension
bracket or bracket
for connecting a
support.
■ PARTS OF THE LINE
Centre feed unit
Flexible joint
78 MS - MINI SBARRA