SR1 Advanced DVB-S2 Receiver GigE interface

More documents

Recommendations

Info

SR1 Operation Manual Rev 1.2 2 About This Document 2.1 Target Audience The target audience for this document is IP over satellite communication professionals. 2.2 Purpose and Applicability This document introduces the setup, configuration, monitoring and troubleshooting of SR1. 2.3 Applicable This document is applicable for all board versions of the SR1. This document is applicable for sw version 1.02bxxx with FPGA 2.01b020 for board versions 2.0 and 4.0 and FPGA fpga_v1.1b281 for boards version 1.0 and 3.0 See details about each board version in chapter 14 See detailed release notes in chapter 13 NOTE – SW upgrade may delete the current configuration. Please make sure you retrieve and save configurations form the SR1 prior to upgrade 6 SR1 Operation Manual Rev 1.2
SR1 Operation Manual Rev 1.2 3 Quick Installation guide Follow the steps described in Table 1 for quick installation of SR1. After any change – type ‘0’ as many times needed to return to main menu – This will store the changes to the non volatile RAM (See more in chapter 6 ) If you typed incorrect value – press ‘esc’ to ignore the entry. Do Verify Reference In this manual Note Connect the USB cable Modify the management port IP address Modify the LAN IP address Set the IP address of default gateway Set ARP mode for the default gateway Connect the Management Ethernet cable Connect the Traffic Ethernet cable Communication with SR1 Ping to the Management and Traffic interfaces to verify connection 10 Install Serial over USB driver and run hyper terminal 6.5 Menu 3.1 6.5 Menu 3.9 6.5 Menu 3.D 6.5 Menu 3.F Verify other network elements are properly configured Set RF frequency 6.3.5 Menu 1.1.1 Set LNB Power 6.3.5 Menu 1.1.E Set 22Khz 6.3.5 Menu 1.1.G Verify RF lock 6.4 RF Lock LED Configure the MPE filter (MAC and PID) Verify traffic to LAN 6.3.6 Menu 1.1.D Use Ping Table 1 - Quick Installation SR1 1.2 Manual rev 1.2 7
Page 1 and 2: SR1 Advanced DVB-S2 Receiver With G
Page 3 and 4: SR1 Operation Manual Rev 1.2 Table
Page 5: SR1 Operation Manual Rev 1.2 1 Tech
Page 9 and 10: SR1 Operation Manual Rev 1.2 SR1 su
Page 11 and 12: SR1 Operation Manual Rev 1.2 o IP f
Page 13 and 14: SR1 Operation Manual Rev 1.2 Interf
Page 15 and 16: SR1 Operation Manual Rev 1.2 5.4 In
Page 17 and 18: SR1 Operation Manual Rev 1.2 6.3.3
Page 19 and 20: SR1 Operation Manual Rev 1.2 For mo
Page 21 and 22: SR1 Operation Manual Rev 1.2 Below
Page 23 and 24: SR1 Operation Manual Rev 1.2 Below
Page 25 and 26: SR1 Operation Manual Rev 1.2 3. ARP
Page 27 and 28: SR1 Operation Manual Rev 1.2 6.6.2
Page 29 and 30: SR1 Operation Manual Rev 1.2 7 Stat
Page 31 and 32: SR1 Operation Manual Rev 1.2 8.5 LA
Page 33 and 34: SR1 Operation Manual Rev 1.2 • SN
Page 35 and 36: SR1 Operation Manual Rev 1.2 Figure
Page 43 and 44: SR1 Operation Manual Rev 1.2 13 Rel
Page 45 and 46: SR1 Operation Manual Rev 1.2 14.4 S
Page 47 and 48: SR1 Operation Manual Rev 1.2 15 SNM
Page 49 and 50: SR1 Operation Manual Rev 1.2 MAX-AC
Page 51 and 52: SR1 Operation Manual Rev 1.2 tunerS
Page 53 and 54: SR1 Operation Manual Rev 1.2 ::= {r
Page 55 and 56: SR1 Operation Manual Rev 1.2 spectr
Page 57 and 58:
SR1 Operation Manual Rev 1.2 linkMa
Page 59 and 60:
SR1 Operation Manual Rev 1.2 SYNTAX
Page 61 and 62:
SR1 Operation Manual Rev 1.2 ::= {r
Page 63 and 64:
SR1 Operation Manual Rev 1.2 counte
Page 65 and 66:
SR1 Operation Manual Rev 1.2 ::= {
Page 67 and 68:
SR1 Operation Manual Rev 1.2 counte
Page 69 and 70:
SR1 Operation Manual Rev 1.2 resetC
Page 71 and 72:
SR1 Operation Manual Rev 1.2 DESCRI
Page 73 and 74:
SR1 Operation Manual Rev 1.2 SYNTAX
Page 75 and 76:
SR1 Operation Manual Rev 1.2 STATUS
Page 77:
SR1 Operation Manual Rev 1.2 -- --
show all

SR1 Advanced DVB-S2 Receiver GigE interface

Create successful ePaper yourself

Delete template?

Save as template?