interstil_2017

ending service
ø tube minimum bending radius
ø 16
60 cm
ø 20
80 cm
ø 25
80 cm
ø 30
100 cm
ø 35
120 cm
not for fluted tube
Notes:
all drawings top view.
deviations +/- 10mm possible.
for complex bends always submit a
template scale 1:1.
smooth curve
T
B
Please specify:
depth T and width B
(distance to wall taken from centre
line of tube)
or template scale 1:1
surcharge 2 195,-
Brass rods can only be bent at a large radius
as the surface of the tube may be damaged
otherwise. The minimum radius depends on
the tube diameter (see below).
For cut rods each rod will be charged for.
alternatives
elbow 90°
with customized angles
Elbows are availble for ø 20, 25, 30 and 35
mm in all finishes. Any angle from 90° up
to 160° available.
surcharge 2 25,-
They can be found in each components
section.
swivel joints
Swivel joints are available for ø 16, 20 and
25 mm in all finishes.
They can be found in each components
section.
mitre connector
Mitre connecors are available for ø 16, 20
und 25 mm.
They can be found in each components
section.
mitre cut
2 19,-
563