аксесуарів та компонентів KLS 2019

ULTIMATE XC 70
SEAT POST
ADVANCED XC 70
SEAT POST
One-piece aluminum head
DIAMETER: 27.2, 30.9, 31.6mm
LENGTH: 400mm
FINISH: sand blasted black
Forged head
DIAMETER: 27.2, 30.9, 31.6mm
LENGTH: 400mm
FINISH: sand blasted black
ACTIVE XC 70
SEAT POST
Die casted clamps
DIAMETER: 27.2, 30.9, 31.6mm
LENGTH: 400mm
FINISH: sand blasted black
CRX/URB 70 S
SEAT POST
Suspended Seat Post
Forged head
DIAMETER: 27.2, 31.6mm
LENGTH: 350mm
FINISH: sand blasted black
CRX/URB 30
SEAT POST
DIAMETER: 27.2, 30.9mm
LENGTH: 400mm
FINISH: sand blasted black,
natural silver
AL 7050 – Strongest aluminum alloy, commonly used in rock-climbing equipment, hang glider frames, military,
automotive and, of course, bicycle industry. Toughest material, but difficult to weld. That’s why it is used mostly for
Handle Bars only.
AL 6061 – Aluminum alloy commonly used in home build or hobby aircraft, yacht constructions or scuba tanks.
Provides very good ratio between strength and affordability.
DOUBLE BUTTED – 2 thicknesses of material are combined to provide best of both – strength and lightweight. Where
the material needs to stand against strong pressure, it is thickened to provide extra strength. On points where the
material is not handling that much pressure, it is thinned to reduce unnecessary weight.
T6 – process of increasing the material hardness by heating the material to a certain temperature for certain period of
time. Times and temperatures may vary based on materials used. This process arranges atoms in molecular structures
which greatly increase the strength of material. Also called “Aging Process”
3D FORGING – Solid block of heated aluminum is compressed into desired mould. Advantage of this technology of
forging is that no welding needs to be used, so the component is lighter and stronger in the end.
BICYCLE / HANDLEBARS, STEMS, SEAT POSTS
129