Membranes Catalog
We are a wholesale supplier of products, solutions and services in water treatment. We provide only businesses companies such as distributors, retailers, manufacturers and assemblers. A catalog that includes products carefully selected from the most prestigious brands in the Water Treatment market, operative site, personalized services, logistics precise and efficient, flexible organization, but also the basic importance that is attributed to human factors and relationships with partners, are of Sinergroup Srl a reference for many companies of the sector.
We are a wholesale supplier of products, solutions and services in water treatment.
We provide only businesses companies such as distributors, retailers, manufacturers and assemblers.
A catalog that includes products carefully selected from the most prestigious brands in the Water Treatment market, operative site, personalized services, logistics precise and efficient, flexible organization, but also the basic importance that is attributed to human factors and relationships with partners, are of Sinergroup Srl a reference for many companies of the sector.
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Membrane 100 GPD Cod. 090018-04
Active surface: 0,46m²(5ft²) * Pressure 4,5bar(65psi) * Production flow(N1) 15,75l/h (100gpd) * Salts
rejection(N2) 97% * Recovery 15%
(N1) Permeated flow and salt rejection based on the following test conditions: 500ppm NaCl, 25ºC (77ºF),
15% recovery
and specified applied pressure. Permeated flows for individual elements may vary +/- 15%.
(N2) Minimum SALT rejection is 95%
Connections:
* Inlet water: O.D. stem Ø 3/8"
* Outlet permeate: O.D. stem Ø 1/4"
* Drain: O.D. stem Ø 1/4"
OPERATING LIMITS OF 50, 75, 100 GPD
* Max. temperature 45ºC (113ºF)
* Max. pressure 21 bar (300 psi)
* Max. P for element 1 bar (15 psi)
* Max feed flow rate 7,6 lpm (2.0 gpm)
* pH range, continuous operation 3 - 10
* pH range, short-term cleaning (30 min) 2 - 11
* Max. Feed SDI 5
* Free Chlorine tolerance¹ <0,1 ppm
¹Under certain conditions, the presence of free chlorine and other oxidizing agents will cause premature
membrane failure.
We recommend removing residual free chlorine by pre-treatment prior to membrane exposure. We
recommend replacing it every 24 months max.
GENERAL INFORMATION
• It is suggested that firs hour of pure water to be rejected.
• Keep elements moist after initial wetting.
• The membrane has a certain short-term resistance against chlorine (hypochlorite). Continuous exposure,
however, may damage the membrane and should be avoided.
• The customer is fully responsible for effects of incompatible chemicals and lubricants on elements.
• Use just glycerine as a lubricant if is needed.
• The use of this product in and of itself does not necessarily guarantee the removal of cysts and
pathogens from water. Effective cyst and pathogen reduction is dependent of the complete system design
and on the operation and maintenance of the system.
Note: The polluting agents removed or reduced by this system are not necessarily in your water.
Code: 090017
Ionicore membrane TFC 2012 - 50, 75, 100, 150, 180 GPD (25)
Features
Permeate flow rate (+/-20%) 50:
Permeate flow rate (+/-20%) 75:
Permeate flow rate (+/-20%) 100:
50 Gpd (190 lt./day)
75 Gpd (284 lt./day)
100 Gpd (379 lt./day)
14 January 2020 6/21
Change language