Instructions for Lutterloh System®

More documents

Recommendations

Info

7. Completing all dots Using the bust measurement, make all dots on the patterns above and including the waist. Change the pin to the hip measurement and draw all dots below the waist. In case that there are more numbers on one line you need to make more dots on your pattern paper. 32079841_Goldener_Schnitt_GB_HG_hellgrau.indd 10 13.04.17 14:59
8. Connecting the dots If a dot is out of line, re-align the dot, according to the pattern diagram. Connect all dots with our special curves. Draw straight lines first, using the straight edge of the ruler, and use curved section to draw armholes, necklines, hip curves etc. After all dots are connected, transfer all symbols from the pattern diagram onto your own pattern, ie: arrow <strong>for</strong> straight of grain. Remove the pattern diagram and mark the pin hole. This is where the pattern is adjusted <strong>for</strong> short-waisted and long-waisted bodies. 32079841_Goldener_Schnitt_GB_HG_hellgrau.indd 11 13.04.17 14:59
Page 1 and 2: The golden Rule ® since 1935 The i
Page 3 and 4: The golden Rule Making fashionable,
Page 5 and 6: 2. Hip measurement Take the widest
Page 7 and 8: 4. Inserting the pin into the scale
Page 9: 6. Making dots The tape rotates fre
Page 13 and 14: 10. Cutting the material The finish
Page 15 and 16: Fabric requirements For every model

Instructions for Lutterloh System®

Create successful ePaper yourself

Delete template?

Save as template?