You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
ESTEK AIR FLOW UNITS
Assembly by Screw:
Screw mounting of the Square Ceiling Diffuser is made with the 3.9x38 mm smart screw
that comes with the product. These screws are painted in product color. Countersunk was
opened to allow the screw to sit properly in the safe section.
(W+90) x (H+90)
Assembly by Latch:
This type of assembly used in cases where the screw is not desired to be seen in the
installation of the Square Ceiling Diffuser. In this application, galvanized “U” plates are
screwed into the box as shown below. The end of the latch installation located in the frame of
the Square Ceiling Diffuser is passed to “U” part and assembly is made.
.
(W+90) x (H+90)
40
t 60-t
0 < t < 45
Assembly by Blind Case :
It is used in cases where the screw is not desired to be seen in the installation of the Square
Ceiling Diffuser. In this application, the blind casing made of galvanized sheet is screwed to
the carrier profile on the ceiling. The clips in the frame of the Square Ceiling Diffuser are
mounted to the blasting on the blind casing and assembly is made.