CC220_Serial Communications

The commands are
C - Change communication settings
This brings up choices for Comm port 1 or 2, and baud rate
600,4800,9600.
The next selection is software or hardware handshake. The
desired selection is hardware, if sw control was not
highlighted.
These changes can then be saved to disk so the next time that
DNC is called up, the settings are recalled when DNC is run from
this directory.
D- Change directory
This will allow the user to change the current directory for
file transfer
S - Send file
This will display a choice to press K to key in the name, or L
to select the files from a list. If L is pressed, move the
cursor to the desired file to send, and press enter, or press K
to key in the name. After file has been selected, press --DATA
IN--START-- on the Bosch control to start transmission. When
hardware handshaking is active, this must be done within 20
seconds.
R - Receive file
This will ask for filename to receive, then opens that file on
the PC. To send the file to the PC, press --DATA OUT-- enter
program(s) to send --START-- . When all programs are finished
being sent, press any key to return to the main menu.
Q – Quit
This will quit the program, and go back to DOS.
14