notebook - Southwest Florida Water Management District

a. One original and two Five copies of the Permit Application for Site Conditions Assessment as identified in
Rule 40D-1.659, F.A.C., including copies of all items and information required for assessment and evaluation by the
District of the existing site conditions, and
b. No change.
7.1.2 Types of Site Conditions Boundary Documentation.
An applicant can request a site conditions assessment permit based upon boundary documentation consisting of
either a certified survey, an approximate delineation, or combinations thereof, as described below. All surveying
and mapping shall be conducted under the responsible supervision of professional surveyor and mapper registered in
the State of Florida.
a. The survey of the extent of wetlands and other surface waters or other site condition boundaries shall be
certified as meeting the minimum technical standards contained in Chapter 61G17-6, F.A.C., by a surveyor licensed
pursuant to Chapter 472, F.S. An applicant proposing a certified survey delineation shall have a survey performed
of the verified boundaries of wetlands and other surface waters and other required or requested site conditions, and
shall have the surveyor or surveyor's representative accompany the District representative during the delineation
verification described in subsection 7.1.3. The certified survey shall also contain a legal description of, and acreage
contained within, the boundaries of the property (contiguous wetlands and project area) for which the permit is
being requested. The boundaries of wetlands and other surface waters or other site conditions shall be witnesses to
the property boundaries, and shall be capable of being mathematically reproduced from the survey. The applicant
shall submit one original and two five line drawing copies of the certified survey, along with one original and two
five copies of the survey depicted on aerial photographs, to the District to complete the application. All vertical
boundaries of site conditions shall be referenced to elevations that are witnessed to and on a site bench mark
established as part of the survey and shown thereon, and referenced to National Geodetic Vertical Datum (NGVD).
The horizontal or topographic extent of vertical boundaries shall be shown on the certified survey in the manner
defined in Chapter 61G17-6, F.A.C.
b. No change.
1.-3. No change.
4. Following any verification and adjustment as required in subsection 7.1.3, the applicant shall submit one
original and two five copies of the following items, as applicable, to complete the site conditions boundaries
18