Thermal and Ignition Barrier Requirements for SPF - Resnet

More documents

Recommendations

Info

Final Comments • Thermal Barriers and SPF • All SPF requires thermal barrier between foam and all interior spaces • If uncovered foam passes 15-minute thermal barrier test, or meets acceptance criteria of corner tests, no thermal barrier covering or coating is needed ©2011 Spray Polyurethane Foam Alliance
Final Comments • Ignition Barriers and SPF • Most closed-cell foams do not require additional ignition barrier coverings or coatings in limited access attics and crawlspaces • Most open-cell foams require additional ignition barrier coverings or coatings in limited access attics and crawlspaces • Always consult evaluation report or third-party fire test reports to confirm ignition barrier requirements for each SPF product. • Always confirm requirements with local code official ©2011 Spray Polyurethane Foam Alliance
Page 1 and 2: ‘Decoding’ Thermal and Ignition
Page 3 and 4: Who is SPFA? • Spray Polyurethane
Page 5 and 6: Objectives • Why Do Codes Require
Page 7 and 8: Why Do Codes Require Ignition and T
Page 9 and 10: Fire Testing Basics: Surface Burnin
Page 15 and 16: Fire Testing Basics: Room-Corner
Page 17 and 18: Fire Testing Basics: Room-Corner ©
Page 19 and 20: Fire Testing Basics: Room-Corner ©
Page 21 and 22: What is a Thermal Barrier? • Two
Page 23 and 24: What is a Thermal Barrier? • Spec
Page 25 and 26: What is a Thermal Barrier? • No t
Page 27 and 28: What is an Ignition Barrier? • Ig
Page 29 and 30: Ignition Barrier Performance PASS I
Page 31 and 32: Fire Testing: Commercial Buildings
Page 33 and 34: Inspection and Verification • Eva
Page 35 and 36: Application Examples Unvented Attic
Page 37 and 38: Application Examples Finished Room
Page 39: Application Examples Space Under Lo
Page 43 and 44: Key References 1. SPFA AY-126 - “

Thermal and Ignition Barrier Requirements for SPF - Resnet

Create successful ePaper yourself

Delete template?

Save as template?