Owner's Manual / Manual del Propietario - Ppe-pressure-washer ...
Owner's Manual / Manual del Propietario - Ppe-pressure-washer ...
Owner's Manual / Manual del Propietario - Ppe-pressure-washer ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
SpeedClean 2400 PSI Pressure Washer<br />
TROUBLESHOOTING<br />
Problem Cause Correction<br />
1. Nozzle in low <strong>pressure</strong> mode. 1. Pull nozzle backward for high<br />
<strong>pressure</strong> mode.<br />
2. Water inlet is blocked.<br />
2. Clear inlet.<br />
3. Inadequate water supply. 3. Provide adequate water flow.<br />
4. Inlet hose is kinked or leaking. 4. Straighten inlet hose, patch leak.<br />
Pump has following problems:<br />
5. Clogged inlet hose strainer. 5. Check and clean inlet hose<br />
failure to produce <strong>pressure</strong>, erratic<br />
strainer.<br />
<strong>pressure</strong>, chattering, loss of<br />
<strong>pressure</strong>, low water volume.<br />
6. Water supply is over 100°F. 6. Provide cooler water supply.<br />
7. High <strong>pressure</strong> hose is blocked or 7. Clear blocks in outlet hose.<br />
leaks.<br />
8. Gun leaks.<br />
8. Replace gun.<br />
9. Orifice is obstructed.<br />
9. Clean orifice.<br />
10. Pump is faulty.<br />
10. Contact local service facility.<br />
Detergent fails to mix with spray.<br />
Engine runs good at no-load but<br />
"bogs" when load is added.<br />
Pressure <strong>washer</strong> stops during<br />
operation.<br />
1. Detergent siphoning tube is not<br />
submerged.<br />
2. Chemical filter is clogged or<br />
cracked.<br />
3. Dirty in-line filter.<br />
4. Nozzle is in high <strong>pressure</strong> mode.<br />
Engine speed is too slow.<br />
Out of gasoline.<br />
1. Insert detergent siphoning tube<br />
into detergent.<br />
2. Clean or replace filter/detergent<br />
siphoning tube.<br />
3. See "Check In-Line Filter".<br />
4. Push nozzle forward for low<br />
<strong>pressure</strong> mode.<br />
Move throttle control to FAST<br />
position. If engine still "bogs down",<br />
contact Briggs and Stratton service<br />
facility.<br />
Fill fuel tank.<br />
16