HOGARTH TALLBOY INSTRUCTIONS - Glasgow Pram Centre

1 introduction
It is advised that 2 people assemble the storage unit, in the room intended for use on a
soft, clean floor so that there is no damage caused to the storage unit during its
construction.
parts list
A. Front panel.
B. Left side panel.
C. Right side panel.
D.Rear panel.
E.Top and Bottom rear support rails.
F. Centre support rail.
G. Top panel.
H. Long bolt.
J .Small bolt.
2 constructing the storage unit
a
K. Long wood screw.
L .Bolt screw.
M. Rear drawer panel.
N. Bottom drawer panel.
P. Top front drawer panel (curved).
Q. Top front drawer panel.
R. Right drawer side with runner.
S. Left drawer side with runner.
T. Safety strap screw and washer.
V. Allen Key.
Insert the rear support top and bottom rails (E) dowels into the holes provided on the right hand side
panel (C).
Insert the rear centre support rail (F) and tighten all the rails using 3 x long bolts (H).
Slot the rear panels (D) into the grooves provided as shown.
b Take the left hand side panel and fit it to the other side and secure it by using 3 x long bolts (H).
c Fit the top panel noting the correct orientation and secure it to the frame using 4 x short bolts (J).
d To fit the front panel (A) carefully align it into the grooves provided by the side panels (B&C)
and push firmly down so it sits flush on top.
Securely attach the front using 8 small bolts (J) as indicated.
The bolts are inserted and tightened from the inside of the frame.
3 constructing the drawers
a
b
c
d
Take one front drawer panel (Q) and right side panel (R) which is indicated by the letter “R”
on the drawer runner. Attach the side panel inserting 2 long screws (K) and tighten
Repeat the above procedure to the left side (the left side panel drawer runner is indicated with a letter
“L”
Slot into the grooves the bottom drawer panel (N)
Attach the rear drawer panel and (M) secure it using two long screws
Note the top drawer front panel is curved (P)
Attached the handle by inserting two screws (L) into the front draw panel as shown
e
4 the safety strap
IMPORTANT:
Although the storage unit is stable, tall furniture, particularly in children’s rooms, should be secured to
a wall to ensure it cannot topple.
A safety strap, washer and domed screw are provided for this purpose.
Fasten one end to the top of the storage unit as indicated. and attach the other end to a sound wall
using wall fixings and screws (not supplied) appropriate to the wall type. If in doubt about how to do
this, consult a builder.