AP1100 n-b.book - AgfaPhoto

AP1100 n-b.book Page 1 Jeudi, 21. septembre 2006 11:17 11
Welcome
ENGLISH
Thank you for purchasing our new photo printer. With this high quality printer you can get the most
out of your digital photos.
The "Crystal Image" and "Red-eye" image optimising functions provide faultless print and copy quality
of your photos.
You will also find the following on the web site www.agfaphotoprinter.com:
• print drivers for PCs,
• a list of answers to frequently asked questions (FAQ).
Safety instructions and recommendations
Do not install your photo printer in a humid room (bathroom, laundry, kitchen, etc.), or within
1.50 m of a tap or water source, or outside. The printer should be operated within an ambient
temperature range of 10 °C to 35 °C. Your printer should be used at an ambient temperature
of between 15°C and 35°C for optimum printing results.
Do not set up your printer in a dusty environment as dust deposits might adversely affect the
print quality of your photos.
Only use the power supply that is supplied (PF60N24AS0 of Shanghai Moons' Automation
Control Co., Ltd). Connect it to a mains outlet in compliance with the installation instructions in
this booklet and the indications stated on the identification label located on the unit (voltage,
current and frequency of the electricity network). As a precaution, in case of danger, the mains
adapters act as a disconnecting mechanism for the 230V power supply. They should be placed
near the device and should be easily accessible.
Never open the top cover when the printer is operating, as you risk breaking the film that may
result a printer malfunction.
After using the printer, wait a few moments after switching the printer off before opening it. To
avoid injury, never touch the print head.
Only use AgfaPhoto consumables, if not you are likely to damage the equipment and
invalidate the guarantee. To obtain the references of the consumables, refer to paragraph
Consumables, page 7.
The CE marking certifies that the product meets the main requirements of the European
Parliament and Council directive 1999/5/CE on telecommunications terminal equipment,
regarding safety and health of users, and regarding electromagnetic interference.
The declaration of compliance can be consulted on the site www.agfaphotoprinter.com, or
can be requested at the following address:
AGFAPHOTO is used under licence of Agfa-Gevaert AG
AP1100 is produced for Sagem Communication and distributed or sold by Sagem Communication
Sagem Communication - Customer relations department
4, rue du Petit Albi - 95800 Cergy Saint-Christophe - FRANCE
1