English - Philips

Searching for the IR-code set
If you cannot find the brand of your device and the corresponding setup
code in the list, you can let the remote control search for the correct
set-up code.
1 Use the Mode key to select the device for which you want to find the
set-up code. Make sure this device is switched on.
The Device indicator lights up.
2 Press and hold for 3 seconds.
The Set-up menu appears.
3 Press in the Set-up menu.
The Search and Exit Setup keys appear.
4 Press and hold the OK key.
The remote control starts transmitting Standby/Power off commands
for the selected device.The Device indicator blinks each time a new
code is sent.
5 As soon as the device switches off, release the OK key. Make sure no
other keys are pressed.
The IR-code set for the selected device has been activated, and the last
accessed page of the device appears on the touch screen.
6 Try out the device specific keys.
If the activated IR-code set is correct, the device specific keys will
function correctly.
If there are keys that do not function properly, repeat instructions 2 to
5 to search for the set-up code again.
Learning Keys
You can let this SRU9400 remote control learn keys from your original
remote control, for example, when a function of the original remote control
is not covered by the touch screen keys.
1 Access the Set-up menu and press .
Page 1 of the last selected device appears on the
touch screen.
2 Place the SRU9400 remote control and the
original remote control within 2 inches’ or 6
centimeters’ distance from each other.
3 Press the key on the SRU9400 remote control
that will learn a key from the original remote
control.
The Learn key remains on.
2 inches
6 cm
Tip You can access other keys of the selected
device with the Page 2 key, or you can select a
different device with the Mode key.
4 Press the key on the original remote control.
A high-pitched beep indicates that the SRU9400 successfully learned the
key.The Learn key blinks twice and the Set-up menu reappears.
-or-
A low-pitched beep indicates that the SRU9400 did not learn the key.The
Learn key blinks once and the Set-up menu reappears.
5 Repeat steps 1 to 4 for each key that you want the SRU9400 remote
control to learn.
5
ENGLISH