M 12V(S) - Hitachi Koki Co., Ltd.
M 12V(S) - Hitachi Koki Co., Ltd.
M 12V(S) - Hitachi Koki Co., Ltd.
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
English<br />
Knob<br />
Wing bolt (B)<br />
Scale<br />
Stopper pole<br />
Fig. 6<br />
Stopper pole<br />
Wing bolt (A)<br />
Fig. 7<br />
(3) As shown in Fig. 6, loosen wing bolt (B). Turning<br />
knob while pulling it outward will cause to move.<br />
Pushing it back and turning will cause stopper<br />
pole to move.<br />
Turn knob while pulling and align the arrow on<br />
stopper pole to “0” of scale. Tighten wing bolt<br />
(B). This condition is the “0” cutting depth.<br />
(4) As shown in Fig. 7, turn back knob and then<br />
tighten the wing bolt (A) when the arrow on the<br />
stopper pole indicates the desired cutting depth.<br />
(5) Loosen the lock lever and press the main unit<br />
down until the stopper pole comes in contact<br />
with the stopper block to obtain the desired<br />
cutting depth.<br />
Cut depth<br />
setting screw<br />
Fig. 8<br />
(6) The two cut-depth setting screws attached to the<br />
stopper block can be adjusted to simultaneously<br />
set three different cutting depths. As shown in<br />
Fig. 8, use a wrench to tighten the nuts so that the<br />
cut-depth setting screws do not come loose at<br />
this time.<br />
Nut<br />
Threaded<br />
column<br />
Threaded column<br />
Nut<br />
(a)<br />
(b)<br />
Fig. 9<br />
(7) As shown in Fig. 9 (a), loosening the two nuts on<br />
the threaded column and moving them down<br />
will allow you to move down to the end position<br />
of the bit when the lock lever was loosened. This<br />
is helpful when moving the router to align the bit<br />
with the cutting position. As shown in Fig. 9 (b),<br />
tighten the upper and lower nuts to secure the<br />
cutting depth.<br />
(8) When you are not using the scale to set the<br />
cutting depth, push up the stopper pole so that it<br />
is not in the way.<br />
16