homeguard ms8000 - IntelliHome

The telephone dialler does not dial out
Check that the telephone plug is connected properly Check that the telephone outlet is
responding to a normal analogue telephone.
False alarms
Reposition the HomeGuard, away from heating elements, direct sunlight, etc. Check that no
pets can trigger the alarm.
ENGLISH
Limited range of the remote
Check the condition of the battery and replace the battery if required. Check if no other
devices interfere on the same frequency e.g. wireless headphones etc.
PIR or siren do not respond
Check that PIR or SIREN has been activated.
The sensor HomeGuard does not react to the remote
Follow the registration procedure in order to lock in the remote. Check that the indicator on
the remote comes on. If not, replace the battery
Any other malfunction
Disconnect the HomeGuard from mains and back-up battery. This will reset the HomeGuard.
Re-install the HomeGuard according to the instruction manual.
Do you still have questions? Please check out www.marmitek.com for more
information.
13. TECHNICAL DATA
MS8000
Power supply:
230VAC 50 Hz, 9V PP3 back-up battery
12 hours stand-by time.
Internal siren:
95 dB(A).
Remote control:
Max. 4 to log-on.
Telephone number selector: Built-in; max. 3 numbers of max. 16 digits.
PIR range:
180º - 6 meter, straight forward - 12 meter (PIR can be switched
off)
RF receiver frequency: 433,92 MHz.
Operating temperature: -10°C till +50°C (operation).
-20°C till +70°C (storage).
HOMEGUARD