You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Rear panel<br />
2. Insert four AA-size batteries, being sure to observe the correct<br />
polarity (“+” and “-” markings), and close the bottom cover.<br />
1. INPUT jack<br />
Connect your guitar to this jack.<br />
6<br />
1 2 3 4<br />
2. OUTPUT/PHONES jack<br />
Connect this jack to your guitar amp, Mixer, Recorder or<br />
headphones.<br />
3. POWER button<br />
To turn the power on or off, press and hold down this button<br />
for 1 second.<br />
4. DC 9V jack<br />
You can connect an optional AC adapter to this jack.<br />
Setup<br />
Installing batteries<br />
Do not mix new batteries and used batteries or different types<br />
of batteries together.<br />
1. Remove the 4 screws from the rubber feet that secure the<br />
bottom cover.<br />
If the battery level becomes low, noise may be generated.<br />
Basic connections<br />
Be sure to connect all cables with the power turned off. If you<br />
fail to use caution when connecting cables, you could damage<br />
your guitar amp or speaker system, or cause other malfunctions.<br />
1. Use a cable to connect the <strong>StompLab</strong>’s OUTPUT/PHONES jack<br />
to your guitar amp,mixer or recorder.<br />
When connecting cables or turning on the power, make sure<br />
to lower the volume of your amp or mixer so that you don’t<br />
hear noise<br />
If you’re using headphones, plug them into the OUTPUT/<br />
PHONES jack.<br />
If you’re using the optional AC adapter, connect it to the<br />
rear panel DC9V power supply jack, and then plug the<br />
adapter into an AC outlet to turn the power on.<br />
2. Connect your guitar to the rear panel INPUT jack.<br />
3. Press and hold the power button and release the switch when<br />
the program/value display lights up.<br />
When the <strong>StompLab</strong> starts, the program/value display will<br />
indicate the program number.