LIGHT UNIT - Exo Terra

Note: For safety purposes it is recommended that either two T8bulbs or two T10 Bulbs be installed. Do not install a combinationof T8 and T10 bulbs.3. Insert the bulb into the end cap so that the pins align with theinternal sockets. Push while inserting the bulb into the end capto ensure a positive connection.4. Once the fluorescent bulbs have been inserted into the endcaps, position the bulbs on top of the metal screen cover of theterrarium (not over the glass as UVB light does not penetrateglass). Ensure that the surface of the screen cover is flat andeven so that the bulbs will not roll. Ensure that the bulbs arepositioned over the top metal screen portion of the terrarium andNOT over any glass, plastic parts, or other flammable material.Failure to do so could result in a possible fire hazard.5. Keep unit out of reach of children. Keep unit away from curtainsor other flammable objects.Maintenance:Warning:• Disconnect the plug of this light unit, and any otherelectrical equipment, used for the terrarium, paludarium oraqua-terrarium before placing your hands in the water; and/orperforming any maintenance of any kind.• Whenever installing, removing or changing fluorescent tubesor maintaining, installing or removing the Exo Terra® LightUnit or any other equipment, always ensure that it isunplugged.• The electrical supply cords of this lighting system cannot bereplaced. If any of the cords are damaged the entire unitshould be discardedCleaning the Unit:1. Do not place the light unit housing near filter outputs or expose itto water spray or humidity. Do not submerge in water.2. Ensure that the heat vents are kept free and clear of anyobstruction, dust and debris. Use a cloth to wipe away anydebris that may obstruct the heat vents.3. No special maintenance is required for the Exo Terra® LightUnit, other than periodic cleaning with a cloth (never use harshchemical products or detergents). To remove calcareousdeposits (bulb sockets), it is recommended to use a mild acidsuch as vinegar, followed by a thorough wipe down with a dampcloth to remove any residues.4. It is strongly recommended to always follow all the precautionsand procedures outlined in both the Important Safeguards andInstallation Instructions sections.NEDERLANDS ITALIANO ESPAGÑOL DEUTSCH FRANÇAIS ENGLISH