ORIGAMI WALKER INSTRUCTIONS - Glasgow Pram Centre

More documents

Recommendations

Info

introductionThe walker is designed to be easy folded for travel and storage but has a widened base forsuperior stability. It has a large table for toys and food and multi height seat adjustment.1 parts list1. Walker 2. Rear Wheel 3. Rear wheel axel pin 4. Caster 5. Seat rest 6. Seat pad 7. Pat mat 8.Toy2 unfolding the walkerTo unfold the walker pull the centre of the walker up until the leg tabs lock into position (a).Rotate the tray upward in the direction shown and put the front leg into position until the front leglockingbutton locks into position (b).WARNING: Double check that the rear leg tabs and front locking leg button are firmlylocked in position.3 attaching the rear wheelsTurn the walker over and attach the rear wheels by inserting the wheel as shown and align the wheelaxle opening with the walker axle opening.Next pull back tab (a) and insert the axle through the wheel and walker axle openings, when the axleis fully inserted release the tab (a) and the axle will be locked in position.WARNING: Double check that the rear wheels are locked in position.4 attaching the castorsPush in the castor until it locks into position as shown, the top of the castor thread must be flush withthe walker, and the thread must not be visible. Repeat for the castor on the other side.WARNING: Double check that the castors are locked in position.5 attaching the seat restAttach the seat rest by firstly inserting in direction (a) and then (b) until the seat rest clicks into place.6 attaching the seat padAttach the seat pad by firstly pulling the crotch to create the seating shape note: the warning label willbe on the outer side.Next place the seat pad over the walker so that the highest point will cover the seat rest.If the cover is in the correct position all the tabs will align with the holes on the walker.Next, pull the tabs through the holes and lock them over the grooves.The seat pad can be adjusted by the buckle at rear to adjust push button (a) and pull the strap in therequired direction.
7 attaching the toysAlign the toy with the hole on the walker as shown, push down the toy until the toy locks into place.WARNING: Toy to be assembled by an adult.WARNING: Do not lift the walker by toys or tray.8 filling and attaching the pat matPull out the valve and while holding the neck of the pat mat and fill with cold water.WARNING: Do not use hot water.WARNING: Do not overfill.Notes:Empty the pat mat and rinse at least once a week.Store only when empty.Avoid dropping the mat when full, as water may spill out.The manufacturer is not responsible for any damage to carpets or floors caused by a water leakage.When the mat has been filled with water place mat on tray as shown.9 friction stripsRegularly clean friction strips with a damp cloth to maintain performance.replacement partsThe replacement parts listed below are available for your product. In the event that you require any of these parts,please contact us atspares@cosatto.comToys Seat pad Seat restCastors Rear wheels Rear wheel axelPat mat
Page 1: ORIGAMI WALKER INSTRUCTIONSF Instru
Page 6: 5ba
Page 12 and 13: EIMPORTANTE:CONSERVAR JUNTO A INSTR
Page 14 and 15: 7 colocación de los juguetesAlinee
Page 16 and 17: introductionLe trotteur a été con
Page 18: YOU’RE GOING TO Love THEORIGAMI W

ORIGAMI WALKER INSTRUCTIONS - Glasgow Pram Centre

Create successful ePaper yourself

Delete template?

Save as template?