BEDIENUNGSANLEITUNG MODE D´EMPLOI USER MANUAL

More documents

Recommendations

Info

and press to transmit the new setting to the energiser. A moving arrow on the Remote Control Fence Compass screen indicates that the command is being sent to the energiser. The large, red light on the left illuminates for 6 seconds as the energiser receives the command. The energiser then resumes in standby mode with only the large, green light on the right flashing. 5. Press to switch off the Remote Control Fence Compass. Tip: Make a note of the address setting of the energiser to save time should the address be accidentally changed or if an additional remote control is required in the future. Building an Electric Fence Components of an electric fence An electric fence system comprises the following elements: • An energiser. • An earth system. This comprises a number of metal stakes inserted into the ground, which are connected to the earth terminal on the energiser. • PATURA insulated underground cables. Used to connect the energiser to the earth and fence. • An insulated fence. Connected to the fence output terminal of the energiser. Fences can be made to a variety of designs (see below). Note: The animal receives a shock when it completes a circuit between the fence and the earth system. The fence has all live wires and requires conductive soils. Earth Fence designs Energiser Earth return Fences can be constructed to suit the type of livestock and materials available. Discuss with your PATURA distributor which design best suits your needs. Permanent electric fencing PATURA offers a range of products that allow the farmer to construct permanent electric fences. A professional permanent electric fence allows the farmer to: • Fence in big areas (fields) - 52 - live live
• Gain ideal conductivity for long fences • Have maintenance-free fences for years Temporary electric fencing PATURA offers a range of products that allow the farmer to construct a temporary electric fence. A temporary fence that can be quickly erected and easily moved allows the farmer to: • Make smaller paddocks (fields) • Keep herds of animals separated • Ration feed Note: Use more wires for smaller animals and wild animals. Polytape should be used when greater visibility is required (e.g. horses). Installing and testing an earth system Select a suitable site for the earth system. Sites need to be: • At least 10 m (33’) from other earth systems (e.g. telephone, mains power or the earth system from another energiser). • Away from stock or other traffic that could interfere with the installation. • At a site that can be easily observed for maintenance. • Ideally at a site that has damp soil (e.g. a shaded or swampy location). Note that the earth does not need to be directly adjacent to the energiser installation. Drive PATURA earth stakes into the ground. Use highvoltage, insulated cable and earth clamps to continuously connect the earth stakes and the energiser’s earth terminal. Make sure the insulation is stripped back to ensure good contact between the wire and the earth rod. All connections need to be screwed together. The number of earth stakes used will vary with the soil conditions. For larger energisers, at least six 1 2 m earth stakes are required. To ensure that an adequate number of earth stakes have been used, test the earth system using the following procedure: 1. Turn off the energiser. 2. At least 100 m (330’) away from the energiser, short circuit the fence by laying several steel stakes or lengths of pipe against the fence. For best results, the fence voltage should be lowered to 2,000 V or less. In dry or sandy conditions, it may be necessary to drive the stakes up to 300 mm (12”) into the earth. 3. Turn the energiser back on. 4. Using a PATURA Digital Voltmeter, ensure that the fence voltage is below 2 kV. 5. Check your earth system. Insert the voltmeter’s earth probe into the ground at the full extent of the lead, and hold the hook against the last earth stake. The tester should not read more - 53 -
Page 1 and 2: BEDIENUNGSANLEITUNG Beachten Sie al
Page 3 and 4: DEUTSCH Elektrozäune und Ihr neues
Page 5 and 6: • Montieren Sie das Elektrozaunge
Page 7 and 8: Mit der Fernbedienung den Zaun ein-
Page 9 and 10: 3. Wählen Sie eine der folgenden O
Page 11 and 12: 12 13 14 15 Hinweis: Leuchtet nur d
Page 13 and 14: den Fall, dass die Adresse unabsich
Page 15 and 16: 4. Vergewissern Sie sich mit einem
Page 17 and 18: Anschlussleitungen und elektrische
Page 19 and 20: Auf dem Elektrozaungerät blinkt ke
Page 21 and 22: Reparaturen nimmt das Elektrozaunge
Page 23 and 24: Français Les clôtures électrique
Page 25 and 26: • Montez l’appareil hors de por
Page 27 and 28: Astuce : la rouille ou l’oxydatio
Page 29 and 30: apparaisse sur l’écran. 4. Appuy
Page 31 and 32: Remarque: lorsque vous ne voyez bri
Page 33 and 34: Montage d’une clôture électriqu
Page 35 and 36: voltmètre sur ce dernier piquet. L
Page 37 and 38: Il faut éviter autant que possible
Page 39 and 40: ne fonctionne toujours pas, portez-
Page 41 and 42: Maintenance L’électrificateur ne
Page 43 and 44: English Electric Fencing and your P
Page 45 and 46: • Connect the earth terminal (gre
Page 47 and 48: 2. Insert the fence wire into the f
Page 49 and 50: ol on the screen. To replace the ba
Page 51: To change the energiser’s address
Page 55 and 56: Electric fence constructions that a
Page 57 and 58: is certified by the manufacturer as
Page 59 and 60: Identifying faults using the LED di

BEDIENUNGSANLEITUNG MODE D´EMPLOI USER MANUAL

Create successful ePaper yourself

Delete template?

Save as template?